2. Dacor
  3. DYWS4
DYWS4

Dacor DYWS4, DYWS4 , 1140151 User guide

  • Hello! I am an AI chatbot trained to assist you with the Dacor DYWS4 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
15.4
Discovery
®
Wine Dispensing System
DYWS4
Revised 01/11/17—Page 1 of 3
Document #PG15-001
All cabinet tolerances: +1/16” (+1.6 mm) -0,
unless otherwise stated.
Technical Specifications/Dimensions
Bottle capacity 4
Power-supply input req’s. 120 Vac, 60 Hz, 2 Amps
Circuit requirement
120 Vac, 60 Hz, 10 Amp. 3-wire (hot–L1, neutral (N1), ground), dedicated circuit
w/grounded 3-prong electrical outlet
Power-cord length 74” (188 cm); u
sable length: 48 in. (122 cm)
Gas-tubing length 117” (297 cm); usable length: 72 in. (183 cm)
Appliance weight (empty) 80 lbs. (32 kg)
Operating (room) temp min. 50°F (10°C); max. 80°F (26.7°C)
WARNING
• Observe all governing regulation during
planning and installation. Contact your
local building department for details.
• This appliance must be installed
according to the provided instructions.
19 9/16”
(49.7 cm)
24 5/8”
(62.5 cm)
25 5/8”
(65.1 cm)
Leveling feet
Adjustable 1” to 4”
(2.5 cm to 10.2 cm)
16”
(40.6 cm)
3 13/16”
(2.1 cm)
3 13/16”
(2.1 cm)
9 5/16”
(23.7 cm)
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
15.5
Discovery
®
Wine Dispensing System
DYWS4
Revised 01/11/17—Page 2 of 3
Document #PG15-001
ALLOW FOR PROPER AIR CIRCULATION
1” (2.5 cm)
min.
NOTES
• The wine-dispensing system must be installed at a safe distance from heat sources (e.g., heaters, ovens, direct sunlight).
• This appliance is designed for indoor use but may be installed outdoors in a covered, dry location and operated within the
required ambient (room) temperature (see Pg. 1).
• All specified maximum/minimum dimensions and clearances must be met or exceeded.
• Due to the possibility of spillage, DO NOT install this appliance above/below another appliance.
• To prevent tipping, do not install this appliance in an unrestrained, free-standing cabinet.
• Install the dispenser only on a flat, level surface that can support its weight; the dispenser must be upright to operate.
• The dispenser must be installed where it is free of potential safety hazards that might impede installation, functionality, or
air circulation around the unit. The location must be clean, dry, and free of debris.
• The dispenser’s 3-prong electrical outlet must be situated so the dispenser can be easily unplugged as needed.
• A minimum space of 13” H x 9” W x 4” D (33 cm H x 23 cm W x 10 cm D) must be provided in a nearby cabinet (within 6
ft. of the dispenser) to accommodate the dispenser’s argon-gas cylinder, regulator, and gas line (with fittings).
• Dacor recommends installating an external UPS with backup battery so the dispenser does not need to be reset after a
power outage.
• Do not plug the dispenser into an electrical outlet that can be turned off via switch or pull chain.
All cabinet tolerances: +1/16” (+1.6 mm) -0,
unless otherwise stated.
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
15.6
Discovery
®
Wine Dispensing System
DYWS4
Revised 01/11/17—Page 3 of 3
Document #PG15-001
DIMENSIONS: OPTIONAL AWSTK24
TRIM KIT
1”
(2.5 cm)
2 1/2”
(6.4 cm)
2 1/8”
(5.4 cm)
24”
(61.0 cm)
24 15/16”
(63.3 cm)
19 3/4”
(50.2 cm)
29 15/16”
(76.0 cm)
Minimum Cutout Dimensions
The figures in this table represent the minimum sizes for the
dimensions of the cabinet cutout based on the size of the
dispenser itself; they are not the suggested dimensions to
use when adding the optional AWSTK24 Trim Kit. (Those
dimensions appear on the graphic to the right.)
Note the shelf and sidewall thicknesses are minimums
for sufficient structural support.
Dimension Inches Centimeters
Cutout width 19 11/16 50.0
Cutout height 26 5/8 67.6
Cutout depth 16 40.6
29”
(73.7 cm)
1 5/8” min.
(4.1 cm)
both sides
21”
(53.3 cm)
24” min.
(61.0 cm)
1 1/2” min.
(3.8 cm)
1 1/2” min.
(3.8 cm)
Standard depth
CUTOUT DIMENSIONS FOR AWSTK24 TRIM
KIT INSTALL
Use the dimensions in this graphic when you install the
optional AWSTK24 trim kit.
All cabinet tolerances: +1/16” (+1.6 mm) -0,
unless otherwise stated.
/