Audioplex PP912 Installation guide
- Category
- Motorcycle Accessories
- Type
- Installation guide
This manual is also suitable for
SHELFTOP IR TARGET
Used as a remote receiver and processor
SPECIFICATIONS:
INSTALLATION:
Connector: Screw type.
Remotes: Will handle almost all standard remote controllers (Note: does NOT work
with B & O equipment, which requires a proprietary confirmation talk-back
function).
Range: 110 feet indoors, 15 to 20 feet in direct sunlight.
Acceptance angle: + or - 55 degrees off center.
Wire: Uses conventional unshielded "zip" or telephone wire.
Power: 12 VDC @ 500 mA (unregulated, included with package)
Your ShelfTop IRTarget is designed to act as a remote receiver and processor of infrared
signals. This sensor will receive signals from remote controllers and send these signals to a
remote repeater. This allows remote operation of any unit from the room where the ShelfTop
IRTarget is located.
CAUTION: Take care to make sure that the ShelfTop IRTarget installation is NOT IN THE
LINE OF SIGHT OR REFLECTION with the repeater. If radiation from the repeater is picked up
by this sensor, a feedback situation is created which will result in instability and unreliable
operation. Undesirable reflection can occur off of light colored walls, windows, mirrors, and even
shiny wood finishes! Also note that the wiring of the unit varies, depending on the type of infrared
equipment that is being used (see back of this page for wiring diagrams). Please call if you have
any questions about your installation.
Any standard type of wire can be used. Shielded or coaxial cable is not usually required
unless the wire passes through some unusually high electrical interference regions.
Prepare the wire leads to and from the Shelftop IRTarget by stripping about 1/4" of
insulation from each of the ends. Twist strands tightly together so that none stick out to cause a
possible short circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in
WARRANTY
Your AUDIOPLEX TECHNOLOGY ShelfTop IRTarget is covered by a Lifetime warranty
against defects in workmanship and materials. Any defects will be remedied without charge for
labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered
by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused
by abuse or by modification or service by an unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the
warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The
products must be returned expences prepaid, with written authorization from the company. The
unit must be shipped with the proof of purchase and in the original carton and packing material
to avoid damage.
NOTE: The following must be specified when ordering: 1. Niles or Xantech compatible 2. 40 KHz or 56 Khz.
TECHNOLOGY
INSTALLATION MANUAL
(Patent Pending)
2002 - 8/23/02
TM
REV B.
TEST
12 vdc system status(optional)
1/8" test input connector
12 vdc power supply
V
G G S
1
S
2
T
WIRING DIAGRAM
(NOTE: 12 volt power supply and Blinker are supplied with package only)
ShelfTop IRTarget
AUDIOPLEX TECHNOLOGY
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 IN N.H. 1-603-544-8601
FAX: 1-603-544-8901
FOR INSTALLATIONS USING AUDIOPLEX TECHNOLOGY INFRARED EQUIPMENT
TM
FOR INSTALLATIONS USING NILES & XANTECH TYPE INFRARED EQUIPMENT
NILES is a registered trademark of Niles Audio Corporation, Inc.
XANTECH is a registered trademark of Xantech Corporation.
NILES or XANTECH PROCESSOR
DATA
GND
+12V
NOTE: The following must be specified when ordering: 1. Specify IRBug or IRFlood 2. 40 KHz or 56 KHz.
BLACK
WHITE
2002 - 8/23/02
SIGNAL
ShelfTop IRTarget
V
G G S
1
S
2
T
ShelfTop IRTarget
V
G G S
1
S
2
T
YELLOW
SIGNAL
-
EMITTER
BLACK
(GROUND)
RED
DEPLUGGABLE
CONNECTOR
Back connections
T
S
G
V
T
V
S
G
T
V
S
G
ROOM 4ROOM 5ROOM 6
SYS-TAT(optional)
SIGNAL
GROUND
12 VDC
DEPLUGGABLE
CONNECTOR
ROOM 2ROOM 3
T
V
S
G
T
V
S
G
T
V
S
G
BLUE
WHITE
BLACK
RED
SYS-TAT (optional)
HARD WIRED
TM
with IRStation
TM
IRStation
(front view)
OUT TO EMITTERS
ALSO AVAILABLE
IN CHASSIS VERSION
POWER 12V
POWER
SUPPLY
BLACK
(GROUND)
POWER 12V
POWER
SUPPLY
BLACK
(GROUND)
REV. B
Jumper S1 and GND in order to start S2 Signal
-
1
-
2
Audioplex PP912 Installation guide
- Category
- Motorcycle Accessories
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Audioplex RC-5 Installation guide
-
-
-
-
-
-
Audioplex STEALTH IR HW Installation guide
-
-
-
Audioplex IRBug Installation guide