2. NORTHSTAR
  3. Remote Sprayer Switch Kit

NORTHSTAR Remote Sprayer Switch Kit Owner's manual

  • I have reviewed the assembly instructions for the North Star 94993 power cord. This document provides information on how to connect the wire harness to the pump power cord and a 12V power supply, as well as troubleshooting steps for issues like no voltage. There are some safety instructions provided. I am ready to answer any questions you may have about this document and the device.
  • How do I connect the wire harness?
    Why is it important to disconnect after use?
    What should I do if there is no voltage?
    What type of fuse should I use?
FIG06477
E94993A
ASSEMBLY INSTRUCTIONS
1. Connect to power
supply and pump
power cord
Connect the wire harness
a) Check to be sure the power switch is in the "OFF" position on the wire harness.
b) Connect the wire harness to the pump power cord.
c) Plug the lighter adapter into a 12V power supply.
2. Disconnect after
use
AFTER EACH USE, disconnect power by disconnecting the wire harness from the
power supply.
NOTE: It is important to disconnect power when not in use, both for safety reasons and to
prevent draining the battery. ALWAYS verify that the power has been disconnected before
servicing.
3. Troubleshooting
If there is no voltage, check fuse inside lighter adapter
a) Remove lighter adapter outer casing
b) Check that fuse is bad, replace with 15A fuse if needed
SAFETY INSTRUCTIONS
NEVER use this switch for applications that draw more than 15 amps.
NEVER leave the wire harness plugged in when unattended, even if the switch is off.
ALWAYS use an appropriate size inline fuse if the motor manufacturer recommends it.
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar Product Support 1-800-270-0810
ITEM NUMBER: 94993
SERIAL NUMBER: _____________
Wire Harness
Pump power cord
To power supply
/