2. GHM
  3. G 1690-MAX

GHM G 1690-MAX, G 1690-35, G 1690T-35 Quick start guide

  • I've reviewed the G 1690 Quick Start Guide and I'm ready to help you with your questions about the O2 Analyser. The document provides instructions on mounting the packed sensor, calibrating it for air measurements, and how to perform basic setups. Feel free to ask any specific questions you might have.
  • How to prepare the device for first use?
    How to calibrate the device?
    What should display appear after calibration?
G 1690 Quick Start Guide V1.1
GHM Messtechnik GmbH | GHM GROUP – Greisinger
Hans-Sachs-Straße 26 | 93128 Regenstauf | GERMANY
info@greisinger.de | www.greisinger.dx
Mounting for devices with packed sensor
Switch on and perform air calibration first:
Press the function key for approx. 5 s until [AL A,R is displayed.
After a few seconds, 100 % ELE[ appears briefly.
The instrument is then ready for measurement and displays: 20.9 vol. % O2.
Commissioning: Calibration in air
Observe the manual for safe operation
Open the can lid, remove the sensor and flow diverter,
Mount small O-ring on flow diverter:
Mount large O-ring on sensor:
Push sensor 1 completely into protective sleeve 3
(sensor is connected to connector 2)
O2 Analyser
for measuring the oxygen
concentration in gases
/