Axxess Interface OESWC-LAN29-STK User manual

Brand: Axxess Interface

Model: OESWC-LAN29-STK

Category: Car kits

Type: User manual

Axxess Interface OESWC-LAN29-STK is designed to allow you to add steering wheel control options to 2006 and up GM LAN29 vehicles. The column mounted OESWC-LAN29-STK will allow you to adjust your radio without taking your eyes off the road. The OESWC-LAN29-STK will come pre-programmed with your most popular features, volume up, volume down, seek up, seek down, and source. But with the option of remapping the buttons to fit every customer needs, this makes this a must have interface that the Axxess line offers.

1-800-221-0932 axxessinterface.com

INSTALLATION INSTRUCTIONS FOR PART OESWC-LAN29-STK

The OESWC-LAN29-STK is designed to allow you to add steering wheel control

options to 2006 and up GM LAN29 vehicles. The column mounted OESWC-

LAN29-STK will allow the customer to adjust their radio without taking their eyes

off the road. The OESWC-LAN29-STK will come pre-programmed with your most

popular features, volume up, volume down, seek up, seek down, and source. But

with the option of remapping the buttons to  t every customer needs, this makes

this a must have interface that the Axxess line offers.

OESWC-LAN29-STK

INTERFACE COMPONENTS

• A) ASWCSTALK • B) OESWC INTERFACE • C) (3) ROD ASSORTMENTS

• D) (2) 3/8 HEX NUTS • E) DECORATIVE NUT • F) (2)ANGLE MOUNT

• G) (2)FLAT MOUNT

• H) TWIST ON COVER • I) VEHICLE T-HARNESS

A B

TOOLS REQUIRED FOR INSTALLATION

•Cutting Tool •Tape •Crimping Tool

•Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors

IGNITION

TERMINALS

WIRE

CUTTER

M3.5

M2.6

ISO

2.5

1.5

*Important: Please check steering shroud before

drilling to make sure you have enough depth.

ASWCSTALK ASSEMBLY

1. Remove and drill a 3/8 hole in the steering wheel shroud.

2. Select desired length rod and thread a 3/8 hex nut on to the shorter

threaded section.

3. Run the four wires from the ASWCSTALK through the rod of choice

and screw it into the ASWCSTALK

4. Take the twist on cover, run the wires through, and twist the cap on to

the ASWCSTALK making sure to align the notches on the cover.

5. Screw the DECORATIVE NUT to the end of the rod with the smaller

end facing the ASWCSTALK

6. Select the desired angle mount and put it on to the rod with the angle

facing away from the ASWCSTALK.

7. Run wires through the steering wheel shroud and insert rod through

the shroud.

8. Secure the ASWCSTALK with the supplied 3/8 nut. (Do not over

tighten)

9. Run wires to where the ASWCSTALK interface will be.

Wiring Of ASWCSTALK And Interface

1. Connect the BLACK wires of the ASWCSTALK and the BLACK wire

of the interface to ground. You may use the same ground point that is

used for the radio.

2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the

ASWCSTALK to the corresponding wires on the interface.

3. Connect the RED wire to 12 volt accessory

4. Tap off all other unused wires on the interface.

Programming the ASWCSTALK

* If this is the rst time the ASWCSTALK is being installed:

1. Turn the ignition on; the led will start ashing rapidly which means the

interface is looking for the ASWCSTALK and the radio. Go to step 3.

* If the ASWCSTALK was installed before:

1. Turn the ignition on, the led will ash slowly

2. Hold down the reset button for more then 2 seconds but less then 10

seconds, the led will start ashing rapidly

3. The ASWCSTALK INTERFACE will automatically nd the

ASWCSTALK and radio.

4. After a couple of seconds the led should stop ashing and not light up

for 2 seconds. At this point do not push any buttons.

5. After the 2 seconds there will be a series of 7 ashes, some short and

some long.

6. The led will pause for another 2 seconds then ash up to 10 times.

7. This is the end of the auto detection stage. If the ASWCSTALK

interface detected the vehicle and the radio successfully the led will

light up solid red.

8. Make sure the steering wheel control buttons function correctly in the

vehicle and enjoy your radio.

If the ASWCSTALK is mounted on the right side of the steering column

follow the instructions below. (Auto-detect must be done rst)

1. Turn the ignition on

2. Press the MODE on the ASWCSTALK for 10 seconds

3. Then press volume up for 2 seconds

4. The ASWCSTALK is now congured for the right side.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on

solid red, it started ashing, or the steering wheel controls did not function

properly. That means the interface did not detect the ASWCSTALK or the

proper radio. Follow these steps to determine what happened:

First some basic tips:

1. Verify that you have 12 volt accessory and a good ground to the

ASWCSTALK and interface.

2. Verify that the 3.5mm connector is connected to your radio securely

and in the correct location.

3. If using the female 3.5mm connector on an Eclipse or Kenwood radio,

verify that the radio’s SWC wire is connected to the correct wire on

the interface.

Once all the information above has been veried and correct, you

will need to put the interface back into auto-detect mode. Follow the

instructions from “If the ASWCSTALK was installed before” section above,

however this time take notice of the led ashes in steps 5 and 6.

1. Volume up

2. Volume down

3. Seek up

4. Seek down

5. Mode (source)

1. Volume up

2. Volume down

3. Seek up

4. Seek down

5. Mode (source)

NOTES

REV. 2/4/11

1-800-221-0932 axxessinterface.com

INSTALLATION INSTRUCTIONS FOR PART OESWC-LAN29-STK

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP certified

technicians

Axxess Interface OESWC-LAN29-STK User manual

Brand: Axxess Interface

Model: OESWC-LAN29-STK

Category: Car kits

Type: User manual

Download PDF

report

Axxess Interface OESWC-LAN29-STK User manual

Axxess Interface OESWC-LAN29-STK User manual

Related papers

Other documents