1
02/04 P/N 211878
© COPYRIGHT 2000 by HUFFY SPORTS
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
Backboard and Rim
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
CAUTION:
THIS BACKBOARD AND GOAL ARE NOT DESIGNED TO
SUPPORT A PLAYER HANGING FROM THE GOAL OR NET.
FAILURE TO OBSERVE THIS CAUTION MAY CAUSE
BODILY INJURY AND / OR PROPERTY DAMAGE.
REQUIRED TOOLS AND
MATERIALS:
• Step Ladder 8 ft. (2.4M)
• (Two) 1/2” Wrenches
• Adjustable Wrench
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO PROPERTY.
WARNING!
2
P/N 211878 02/04
LEVER
1
2
BROOM
HANDLE
201257 3/99
1
2
4
3
MOVING SYSTEM
1. Adjust basketball backboard
height to lowest position.
2. While holding pole, rotate
basketball system forward
until wheels engage with
ground.
3. Move basketball system to
desired location.
4. Carefully rotate basketball
system upright.
5. Reattach ground restraint and
check system for stability.
HEIGHT ADJUSTMENT
TO ADJUST BACKBOARD:
1. TO RAISE BACKBOARD:
Slowly push up on the rim broom
handle or wooden dowel,
3/4”- 7/8” (19mm - 22mm) diameter
as shown to engage locking
mechanism at desired height.
2. TO LOWER BACKBOARD:
Push lever up to unlock and
carefully lower backboard to lowest
position.
with
50
WARNING
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT
IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
Owner must ensure that all players know and
follow these rules for safe operation of the unit.
In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339
In Australia: 1-800-632-792
206118 5/97
See instruction manual for proper installation and
maintenance.
Use caution when performing dunk type activities on this unit.
Do not hang from any part of unit, including backboard,
support braces, rim or net.
Check unit before each use for loose hardware, excessive
wear and signs of corrosion and repair before using.
During play, use extreme caution to keep player's face away
from the backboard, rim or net. Serious injury could occur if
teeth/face come in contact with backboard, rim or net.
During play, do not wear jewelry (rings, watches, necklaces,
etc.) Objects may entangle in net.
·
·
·
·
·
·
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• Read and understand the warning label enclosed with hardware. It is
the responsibility of the customer to mount this label. It should be
affixed to the pole, wall, or door near playing area, at a height between
4-6 feet (1.22-1.83M) above ground level and in a location visible to all
players.
• During assembly, if using a ladder use extreme caution. Two people
are recommended for this operation.
• If technical assistance is required, contact Huffy Sports.
• Serious injury could occur if teeth/face come in contact with
backboard, net or rim.
• Minimum operational height should be 6’6” (2M) to the bottom of
backboard.
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe
operation of the system.
To ensure safety, do not attempt to assemble this system without following
the instructions carefully. Proper and complete assembly, use and
supervision is essential for proper operation and to reduce the risk of
accident or injury. A high probability of serious injury exists if this system is
not installed, maintained, and operated properly. Check entire box and inside
all packing material for parts and/or additional instructional material. Before
beginning assembly, read the instructions and identify parts using the
hardware identifier and parts list in this document.
For more information on assembly, placement, proper use and
maintenance, visit The American Basketball Council website at
http://www.smarthoops.com.
02/04 P/N 211878
3
For more information on assembly, placement, proper
use, and maintenance, visit The American Basketball
Council website at http://www.smarthoops.com.
IMPORTANT!
Remove all contents from boxes.
Be sure to check inside pole sections;
hardware and additional parts are packed inside.
NOTICE TO ASSEMBLERS
ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled
and ballasted with sand or water according to the instructions. Failure to follow instructions
could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.
WARRANTY CARD:
Please remember to complete your product
registration form either on-line at:
www.huffysports.com or mail-in the
enclosed postcard.
4
P/N 211878 02/04
PARTS LIST - See Hardware Identifier
Item #2 (4)
Item #5 (6)*
Item #4 (6)
Item Qty. Part No. Description
1 1 206118 Warning Label
2 4 203113 Hex Flange Bolt 5/16-18 x 2.5 Long
3 2 203038 Bolt, Carriage 5/16-18 x 2.75 Long
4 6 203309 Washer, 1 O.D.
5 6* 203100 Hex Flange Nut, 5/16 x 18
61 Rim
7 12* 201219 Clips, Net Holder Smart Clip
81 Net
9 1 203365 Rim Spacer
* You may have extra parts with this model.
Item #7 (12)
Item #3 (2)
ASSEMBLY INSTRUCTIONS
IMPORTANT! WRITE MODEL NUMBER FROM BOX ONTO PAGE 1 OF THIS OWNERS MANUAL
WARNING: TWO PEOPLE ARE NECESSARY TO MOUNT THE BACKBOARD ASSEMBLY TO SUPPORT STRUCTURE. ONE PERSON
SHOULD NOT ATTEMPT TO DO THIS ALONE.
WARNING: MOUNTING THE BACKBOARD ASSEMBLY TO THE SUPPORT STRUCTURE IS PERFORMED AT AN ELEVATED HEIGHT. USE
PROPER PRECAUTION.
WARNING: IT IS RECOMMENDED TO MOUNT BACKBOARD TO A SOLID (STEEL) SUPPORT.
1. Attach Backboard and rim using one of the options as shown.
WARNING: USE OF THIS PRODUCT WITHOUT PROPER INSTALLATION OF SMART CLIPS, OR WHEN ALL SMART CLIPS ARE NOT
PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CAREFULLY.
2. Install net clips as shown (See Illustration).
3. Install net as shown (See Illustration).
4. Place warning label (1) in location clearly visible within playing area.
1. Mounting Options “A, B or C”
HARDWARE IDENTIFIER
02/04 P/N 211878
5
5
5
4
8406 Bracket
(not supplied)
5
2
4
3
6
5
5
3
2
3
3
5
Mount extension arm and rim to backboard.
Attach backboard assembly to bracket as
shown.
UNIVERSAL MOUNTING BRACKET INSTALLATION
EXTENSION ARM INSTALLATION
1A.
1B.
4
6
6
P/N 211878 02/04
5
5
3
5
2
3
REGULATION RIM HEIGHT
IS 10 FEET (3.05M).
4
10 feet
3.05 m
Bend top of backboard brackets (40) outward to match
up with holes on the backboard and secure using nuts
(17) and bolts (43) as shown. Attach rim (32) to
backboard using using bolts (42) and nuts (17) as
shown.
ELEVATOR INSTALLATION
1C.
02/04 P/N 211878
7
Pole bracket will need to be lightly pressed into backboard ribbing. Be sure to press completely into place. Attach
rim to backboard and pole bracket with knob, reinforcement bracket, and carriage bolt as shown. Tighten knob
completely.
Carefully tip unit forward and slide backboard assembly onto pole as shown.
PRESS BRACKET INTO
PLACE HERE
SAWHORSE OR SUPPORT TABLE
Aucun outil
requis
Assemblage
facile
Economie de
temps de 40 %
1D.
INSTALLATION
8
P/N 211878 02/04
ATTACH SLAM JAM RIM (Not Supplied)
REQUIRED
9
REQUIRED
9
REQUIRED
9
02/04 P/N 211878
9
2.
CLIP “ARM”
CLIP “BODY”
AA
BB
CC
7
Install net clips.
6
Insert one “arm” of clip (19) into ram (18) as shown. Twist “body” of clip slightly so that
second “arm” slides over the top of the first “arm” as shown.
Push in direction indicated by arrows.
Push second “arm” back and into ram as shown.
Twist “body” of clip slightly again to spread “arms” of clip.
Clip “arms” must be flat and touching edge to edge as shown, not overlapping.
WARNING:
Use of this product without proper
installation of net clips, or when all net
clips are not present could result in
bodily harm. Be sure to follow
directions carefully.
10
P/N 211878 02/04
3.
NET INSTALLATION
Install net.
Insert net into bottom of clip as shown.
SIDE VIEW
Twist net until it snaps into position.
Net must be centered through clip.
NET
NETCLIP
6
7
8
SIDE VIEW
NET
NETCLIP
/