983000-418
4-04
Figure 1
Figure 2
Figure 3
Figure 4
1. Stop the engine.
2. Remove the bumphead as-
sembly from the drive shaft by
unscrewing the spool retainer.
See Figure 1.
PRO-CUT
™
HEAD ASSEMBLY REPLACEMENT
3. On Pro-Cut
™
Head, place center
of Duraline
™
pre-cut string under
the notch and pull tight. See
Figure 2.
4. Thread string through eyelets on
either side and pull tight. See
Figures 3 and 4.
5. Install Pro-Cut
™
Head Assembly
on drive shaft. Secure with exist-
ing spool retainer removed in
step 2 above. See Figure 4.
Figure 5
/