PERIMETER TRIM KIT
GA6094, GAB6094, GACB6094
and GAP6094
FITS CDCF, CGCF, VDCF, VMH26, VMH10, FDCF
AND FMH26 SERIES
COMPACT VENT-FREE GAS FIREPLACES
Includes Hardware Kit 102866-01
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
www.desatech.com
107233-01
REV. B
04/03
NOT A UPC
Side Trim
Figure 1 - Assembling Perimeter Trim
Slot
Installing Perimeter Trim
1. Fireplace should be fully assembled. See Assembling
Fireplace in fireplace owner’s manual.
2. Firmly snap trim assembly on shoulder screws. Shoulder
screws are located on fireplace cabinet (see Figure 2).
Assembling Perimeter Trim
1. Remove packaging from three remaining pieces of trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 1.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 1).
5. Slide other end of adjusting plate/shim in slot on mi-
tered edge of side trim (see Figure 1).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
Top Trim
Mitered Edge
Shim
Set
Screws
Adjusting
Plate
Slot
Figure 2 - Attaching Perimeter Trim to Fireplace
Shoulder Screws
Assembled
Perimeter Trim
107233 01
-
1
FMI GAB6094 Operating instructions
- Type
- Operating instructions
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
FMI GA6094 Operating instructions
-
-
-
Desa Tech HDFB32CA Owner's manual
-
-
-
-
Vantage Hearth VMH26TPC User manual
-
FMI VMH26TPC, VMH26TNC User manual
-
Comfort Flame CGCFTPA User manual
