Page is loading ...
Setup Guide
WARNING:
Drum key can be pinched when adjusting clamps with drum key. Operate carefully.
1. Open packing box 2. Remove the Foam Blocks and Pedals
3. Take out the Drum set
right f ront H older B
Wing N ut A
4. Loosen W ing N ut A a nd O pen t he right f ront Holder B
and then t ighten W ing N ut A
left f ront H older D
Wing N ut C
5. Loosen W ing N ut C a nd o pen t he l eft f ront H older D , a nd then t ighten W ing N ut C
Cymbal S upport F
Wing N ut E
7. Loosen Wing Nut G, adjust the Cymbal H
, then tighten Wing Nut G.
as shown
in the illustration
8. Loosen W ing N ut I , a djust D rum K a nd M odule J
, t hen t ighten Wing N ut I.
as
shown in the illustration
Wing N ut I
Cymbal H
Wing N ut G
Drum K
Module J
6. Loosen W ing N ut E a nd p ull u p C ymbal Support F , a nd then t ighten W ing N ut E
9. Loosen W ing Nut L, r emove t he D rum N to t urn i t 180° a nd i nsert i t t o C lamp M , t hen t ighten W ing Nut L.
Wing N ut L
Drum N
Clamp M
10. Loosen W ing N ut O , a djust C ymbal S upport P , t hen t ighten W ing N ut O .as shown in the illustration
Wing N ut O
Cymbal S upport P
11. Loosen H andle Q , p ull u p t he Straight H older R
, t hen t ighten Handle Q .as shown in the illustration
12. Place the Hi-Hat Pedal S and Kick Pedal T in the
center of Rack.
Straight H older R Hi-Hat Pedal SKick P edal T
Handle Q
13. Connect t he C able t o D rum M odule as show n with Handscrews.
Drum
Module Snare
Tom2 Tom2
Crash Ride
Hi-Hat
Kick
Pedal
Hi-Hat
Pedal
Tom 3
Tom3
14. Make connection s as shown in the illustration.
Crash
Hi-Hat
Drum Module
Ride
Tom 1 Tom 2
Snare
Tom 3
Hi-Hat Pedal PedalKick
/
