RehabMart LR200SF User manual

Type
User manual

RehabMart LR200SF

The RehabMart LR200SF is a single-fold aluminum ramp with a 600-pound weight capacity. It is designed to provide safe and easy access for wheelchairs, scooters, and other assistive devices. The ramp is lightweight and portable, making it easy to transport and store.

The LR200SF features a non-slip surface for added safety and security. It also has a top flange that overlaps the step by at least 1 1/2 inches, providing a secure connection to the landing. The ramp is designed to be used on a level surface and should not exceed the recommended manufacturer's degree of incline.

RehabMart LR200SF

The RehabMart LR200SF is a single-fold aluminum ramp with a 600-pound weight capacity. It is designed to provide safe and easy access for wheelchairs, scooters, and other assistive devices. The ramp is lightweight and portable, making it easy to transport and store.

The LR200SF features a non-slip surface for added safety and security. It also has a top flange that overlaps the step by at least 1 1/2 inches, providing a secure connection to the landing. The ramp is designed to be used on a level surface and should not exceed the recommended manufacturer's degree of incline.

SINGLE FOLD
ALUMINUM RAMPS
Determine the recommended degree of incline for
your assistive device (scooter, wheelchair, etc) by
referring to your owner's manual
• Measure the distance from the top step or landing to
the ground (RISE).
• Refer to Incline Chart to find the proper ramp length.
• Always use a qualified assistant when using a ramp.
1. Your ramp has a 600 pound weight capacity. Please
remember this is determined by adding your weight to
that of your assistive device.
2. Always inspect the surface of the ramp for anything
that could be slippery such as water, ice, oil, etc. Clean
surface if anything is found. Also, remove any debris
such as branches, twigs or rubbish before use. While
inspecting ramp, always check for worn or damaged
parts. If any problems are found, do NOT use the
ramp. Contact your dealer for assistance.
3. Always secure the top flange of your ramp on a level
surface and make sure the top edge is overlapping the
step by at least 1 ½ inches. Make sure the bottom of
the ramp rests securely on the ground.
600 LBS
WEIGHT CAPACITY
Rhythm Healthcare, LLC ramps are covered with a three
(3) year transferable warranty. Please see warranty
certificate for details.
WARRANTY
4. Always secure the pins firmly in the holes at the
top of the ramp. Holes will need to be drilled into
the surface in which you are using the ramp to
properly secure it and maintain your safety.
5. Do not exceed the recommended
manufacturer's degree of incline when using your
ramp. Doing so may cause your power chair or
scooter to tip forwards or backwards resulting in
harm to the patient.
6. Do not add or modify your ramp in any way.
THIS WILL VOID YOUR WARRANTY.
7. Frequently inspect your ramp to make sure that
the bolts, nuts, and hinges are tight and property
secured.
8. When using your ramp for access into a van:
NEVER ride your assistive device into or out of the
vehicle! Manually push the assistive device into
and out of the vehicle.
9. Always use the single-fold ramp in the full
open position only!
10. When using the ramp with a wheelchair
always have a qualified attendant with you and
ALWAYS go down the ramp backwards, it is highly
recommended that a lap belt be worn for safety.
11. Please check the ramp usage chart, to deter-
mine which ramp length is best in your applica-
tion. Failure to do this may cause injury.
LR200SF
LR300SF
LR400SF
LR500SF
LR600SF
Rhythm Healthcare, LLC | Lifestyle Mobility Aids
3200 Tyrone Blvd N
St. Petersburg, FL 33710
Email: contactus@rhythmhc.com
Website: www.rhythmhc.com
v2: 4/9/21
USER INSTRUCTIONS
  • Page 1 1

RehabMart LR200SF User manual

Type
User manual

RehabMart LR200SF

The RehabMart LR200SF is a single-fold aluminum ramp with a 600-pound weight capacity. It is designed to provide safe and easy access for wheelchairs, scooters, and other assistive devices. The ramp is lightweight and portable, making it easy to transport and store.

The LR200SF features a non-slip surface for added safety and security. It also has a top flange that overlaps the step by at least 1 1/2 inches, providing a secure connection to the landing. The ramp is designed to be used on a level surface and should not exceed the recommended manufacturer's degree of incline.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI