2. &Tradition
  3. Passepartout JH10 JH11 JH12

&Tradition Passepartout JH10 JH11 JH12 User manual

  • Hello! I've reviewed the instructions document for the Passepartout JH10, JH11, and JH12 lamps designed by Jaime Hayon. This document provides details on the installation process, safety precautions, and cleaning instructions. It seems these indoor lamps are equipped with 12W LED light source and also dimmable. I'm ready to answer any questions you may have about these lamps or the contents of the document.
  • What type of light source does the lamp use?
    Is the lamp dimmable?
    Where is the lamp intended to be used?
    What should I use to clean the lamp?
Congratulations with your new Passepartout lamp,
designed in 2016 by Jaime Hayon. We hope you will
enjoy using this product and follow these instructions
to ensure correct installation. If you have any questions
or comments, please do not hesitate to contact us by
mail on:
[email protected]
Passepartout JH10-JH12
Jaime Hayon
2016
Instructions
A
B
Passepartout
JH10-JH12
Jaime Hayon
2016
C
01/22
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these in-
structions correctly. Do not modify this product in any way.
Content
A Lamp shade
B Distance ring
C LED module (including terminal block)
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- Keep product well out of children’s reach.
- The lamp is only intended for interior use.
- Consult a professionally qualified electrician if in any doubt.
- Do not place the cable within reach of small children or
anywhere there is a risk of falling over it.
Cleaning instructions
- Wipe surface of the lamp with a soft dry cloth.
- Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or stiff brushes.
Step 1
Use the terminal block inside the junction box to assemble
the wires from the LED module with the wires from the
power supply.
Connect the blue supply wire to the blue fixture wire.
Connect the brown supply wire to the brown fixture wire.
Close the junction box and place it inside the cavity in the
back of LED module.
Step 2
Mount the distance ring and the LED module on the
surface,using appropriate plugs and screws. Do not
remove protective plastic cover until LED module has
been properly fixed.
Important! The distance ring can be left out if the LED
module is installed directly ontop of a power outlet.
Step 3
Remove the protective plastic cover by turning
counter-clockwise.
Step 4
Attach the lamp shade onto the LED module by turning
clockwise. Be careful not to touch the LED chips during
installation.
JH10 JH11 JH12
Power Supply
Terminal Block
LED module cable
For indoor use only
12W LED, 2700 K
CRI < 90, dimmable
andtradition.com
/