2. Pioneer
  3. RYB/RB Series Slim Duct Concealed Air Handlers

Pioneer RYB/RB Series Slim Duct Concealed Air Handlers Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Pioneer RYB/RB Series Slim Duct Concealed Air Handlers Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page 1
1. Disassembly
 
1. Electrical parts (Antistatic gloves must be worn.)
Procedure Illustration
1) Remove 5 screws of the cover of
electronic control box and then
remove the cover. (see Figure 1.)
2) Remove the 2 screws of the electronic
control box. Then release the 2
hooks of the main control board.
(see Figure 2).
Figure 1
Figure 2
Note: This section is for reference only. Actual unit appearance may vary.
Disassembly Guide for RYB/RB Slim-Duct Concealed Air Handler
Applies to Models with Nomenclature of "RBxxxGMFILxFHD".
Page 2
 
Procedure Illustration
3) Disconnect the connectors and then
remove the front main control
board (see Figure 3).
4) Turn over the electronic control box.
Disconnect the connectors and remove
the 2 screws of rear main control
board (see Figure 4).
Figure 3
Figure 4
Note: This section is for reference only. Actual unit appearance may vary.
Procedure Illustration
5) Remove 2 screws of reactor and remove
the reactor (see Figure 5).
Figure 5
Note: This section is for reference only. Actual unit appearance may vary.
Page 3
 
2. Fan motor and fan
Procedure Illustration
1) Remove 10 screws of the top cover
and then remove the top cover
(see Figure 6).
2) Release the 8 hooks of volute shell
(see Figure 7).
Figure 6
Figure 7
Note: This section is for reference only. Actual unit appearance may vary.
Page 4
 
Procedure Illustration
3) Remove the fixing screws of fan (2
screws) (see Figure 8).
Figure 8
Note: This section is for reference only. Actual unit appearance may vary.
Page 5
 
3. Evaporator
Procedure Illustration
1) Remove 9 screws of the water collector
and remove the water collector
(see Figure 9).
2) Remove the screws of the pipe clamp
board and the left side board (3 for
the pipe clamp and 9 for left side
board) (see Figure 10).
Figure 9
Figure 10
Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.
Page 6
 
Procedure Illustration
3) Remove the 2 fixing screws of the
evaporator support and then
pull up the temperature sensor
(see Figure 11).
4) Remove the fixing screw of the
evaporator and then remove it
(see Figure 12).
Figure 11
Figure 12
Note: This section is for reference only. Actual unit appearance may vary.
Page 7
 
/