OMIX 12040.09 Installation guide

Hello! I've reviewed the installation instructions for the Bumper Applique Rear JK. This document outlines the steps for attaching the applique to your vehicle's rear bumper, including removing the bumper and using self-tapping screws. I'm ready to help answer your questions about the installation process or any features mentioned in the document.
How many bolts need to be removed to detach the bumper?

How many bolts are holding each side of the bumper to the frame?

How many screws are used on the top of the cover?

How many screws are used on the bottom of the cover?

12040.09

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.

Step 1. Remove the rear bumper. Remove the (6) bolts from the back of the bumper as shown. There are (2)

bolts holding each side of the bumper to the frame and (2) in the center of the bumper. Do not discard

the bolts, they will be used to re-attach the bumper.

Step 2. Place the cover over the center section of the bumper. Using light pressure hold the cover ush

against the bumper. Use the supplied self-tapping screws to attach the cover. Install (6) screws top

and (4) screws bottom in the pre-drilled holes in the cover. Re-install the bumper onto the vehicle.

Page 1 of 1

Rev 5/11 SB

BUMPER APPLIQUE REAR JK

X1 X1

X6 on top

X4 on bottom