Premier Mounts PP-5 Operating instructions

This document provides installation instructions for the PP-5 mount. It details how to securely install the mount to a ceiling structure and how to attach a pipe for adjustable suspension. The document also includes a warning about ceiling weight capacity.
What size pipe is used with the PP-5 mount?

How is the pipe secured to the PP-5 mount?

Can the PP-5 be used with other suspension adapters?

What is the minimum ceiling support capacity for the device?

Installation Instructions

PP-5

Step 1

Install the PP-5 securely to the ceiling structure in accordance with proper commercial standards. Use ( commercially

available ) suitable hardware depending on the installation requirements.

Step 2

Install the desired length of 1-1/2” diameter NTP pipe with threaded ends for the PP-5. Install the lower PP-5

to the bottom ends of the pipe. Place the ¼”x20x1/2” locking screw to each PP-5 to secure the pipe so that the

pipe will not swivel.

2980-A Enterprise Street, Brea, Ca. 92821 / Ph. (800) 368-9700 Fax (800) 832-4888

E-mail: [email protected] http://www.pmpi.com 02/98

www.touchboards.com 205 Westwood Ave.Long Branch, NJ 07740 1-866-942-6273 [email protected]

Step 3

Install the base box to the bottom PP-5 using four ( 4 ) M10x25mm nut bolts, bolts and washers ( supplied ).

NOTE: For more adjustable suspension the PP-5 can be mated directly to our ASA-2446 suspension adapter using four

( 4 ) M10 x 25mm nut bolts and washers ( supplied ).

WARNING!

The ceiling should be capable of supporting a weight of at least five times the projector or monitor

weight. If it cannot, the ceiling must be reinforced. Proper installation procedure by qualified personnel

as outline. In the installation instructions must be adhered to. Failure to do so could result in serious

personal injury.

For further information or ordering assistance contact us at the address shown on the front of this page.