2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Fishbone Offroad
  7. FB25220

Fishbone Offroad FB25220 Installation guide

  • Hello! I've reviewed the installation instructions for the FISHBONE OFFROAD Tailgate Table designed for the Jeep JL Wrangler. This document outlines the necessary steps for installing the table, including tools and parts needed, and I'm ready to answer your questions about the process or the product itself.
  • What tools are required for installation?
    What does the kit contain?
    What type of vehicle is this table designed for?
FB25220
Jeep® ’18-Current JL Wrangler
Tailgate Table
REQUIRED TOOLS
Drill
9/16” Drill Bit
4mm Allen
5mm Allen
Tape Measure
Pen/Marker
KIT CONTAINS
Tailgate Table
Cutting Board
M6 Button Head Bolt
M8 Button Head Bolt
M6 Oversized Washer
M8 Washer
Spacer
QTY
1
1
3
1
3
1
3
FB25220
Jeep® ’18-Current JL Wrangler
Tailgate Table
1
1) REMOVE AIR VENT
Open your vehicle’s tailgate and begin removing its
air vent interior panels, by carefully and evenly
pulling out its body clips.
The installation will be using these 4 mounting
points.
2) MEASURE & DRILL
Flip the main panel over. With a tape measure,
measure 1-5/8” left of the shown plastic rib, and
down 3/8” from the shown vent.
Mark this intersecting point. This will be your drill
point.
With a drill, drill a pilot hole and work your way up
to a 9/16” drill bit.
3) REPLACE & INSTALL
Reinstall the main panel and ensure the drilled hole
lines up with the lowest mounting point.
FB25220
Jeep® ’18-Current JL Wrangler
Tailgate Table
2
Open the table and place it up against the panel.
With three of the smaller bolts, washers, and
spacers, secure the top three holes with a 4mm
Allen wrench.
Finally, with the larger bolt and washer, secure the
bottom drilled hole with a 5mm Allen Wrench.
4) ENJOY YOUR NEW FISHBONE OFFROAD JL
TAILGATE TABLE!
/