Page is loading ...
VisionNet M504 Page 1
Vision Net M504
The VisionNet M504 is a router and DSL modem combo unit. It is a DSL modem and will also work with the fiber network
using port 4 the ‘Omni-Port’
To log into a VisionNet, set the of the laptop or PC LAN connection to DHCP and the Ethernet cable is plugged into ports
1,2 or 3
Open a browser and type 192.168.1.254 press ‘enter’ the user id is admin the password is 0123456789
VisionNet M504 Page 2
The welcome screen looks like this
Click on the ‘WAN’ link on the left
VisionNet M504 Page 3
It will expand, click on ‘WAN Services’
Click on the ‘edit’ button for the atm0 Interface
VisionNet M504 Page 4
Click on the ‘Next’ button
Ensure the ‘Obtain an IP automatically’ is enabled
VisionNet M504 Page 5
If not then, click in the radio button then click next
Click ‘Next’
VisionNet M504 Page 6
Click the ‘Apply/Save’ button
Click the ‘Apply/Save’ button
VisionNet M504 Page 7
Your done setting up the router for DHCP, while you are here check the firmware and update it if it is older than
GAN5.CZ56T-B-DQ-R4B069-US.EN_12_update
Older versions are
GAN5.CZ56T-B-DQ-R4B069-US.EN_fs_kernel and GAN5.CZ56T-B-DQ-R4B056-US.EN
The firmware version is on the QuickView screen
VisionNet M504 Page 8
To update the firmware, click on the ‘Management’ link
Click on ‘Firmware Upgrade’ link
VisionNet M504 Page 9
Click the ‘Browse’ button and find the software then click the ‘Upgrade Software’ button
The software will update then reboot the router
/
