Specification Revised 9/04
JBP80SH/TH/WH/KH/CH/BH – GE
30" Free-Standing CleanDesign Electric Range
Dimensions and Installation Information (in inches)
*Dimension from wall to front of closed door handle is 27-3/8
Check local codes for required breaker size.
Code requires that new construction (not existing)
utilize a 4-conductor connection to an electric range.
Locally approved flexible service cord or conduit must be used because terminals are not accessibl
after range installation. See shaded area in drawing for location of electrical outlet box.
Recommended outlet locations allow range to be installed directly against wall.
Conforms to U.L. requirements for 0" spacing for adjacent walls below countertops. To reduc
possibility of scorching walls, it is recommended a minimum of 1-1/2" spacing be allowed from
adjacent side walls to allow for possible extended, high-heat, no-load heating element operation.
Installation Information:
Before installing, consult installation instructions packed with product
for current dimensional data.
30
25
2-1/2
7-1/2
29-7/8
25-3/8*
47-5/8
46-7/8
2-1/2
Acceptable electrical
outlet area
Preferred electrical
outlet area
Roughed-in dimensions
Electrical outlet locat ABC.eps
For answers to your Monogram
appliance questions, visit our website at
ge.com or call GE Answer Center
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation