5
7
8
VII. PROGRAMMING THE FOOT DRIVING
PROFILE
SETTINGS PERTAINING TO THE RESPONSIVENESS
Your wheelchair is programmed with a basic factory setting which can be
changed using a doogle R-net and R-net programmer.
!
WARNING
Programming must be carried out by a professional approved by Logo
Silver (your dealer for example).
- Minimum forward, reverse and turning speed (Fig. 7)
These parameters modify the minimum speed for a small joystick
manipulation. The larger this parameter, the more aggressively the
wheelchair will react upon starting.
- Minimum forward, reverse and turn acceleration (Fig. 7)
These parameters modify the minimum acceleration for a small
manipulation of the joystick. The greater this setting, the greater the
acceleration will be at startup.
- Minimum forward, reverse and turn deceleration (Fig. 7)
These parameters modify the minimum deceleration for a small
manipulation of the joystick. The greater this setting, the greater the
deceleration will be abrupt.
- Controls Joystick forward, reverse, left and right throw (Fig. 8) :
These parameters allow you to adjust the joystick stroke. At the lowest
setting, the greater the reaction will be in the set direction.We advise you
to set these 4 parameters to the same value in order to avoid the risk of
having a diffi cult chair to drive.
- Motor global compensation (Fig. 8) :
This parameter is used to adjust the general power. The higher this
setting is, the more responsive the wheelchair is (accelerating, braking
and turning faster). If you modify this parameter you must also modify
the speed, acceleration and deceleration parameters in the indoor and
outdoor driving profi les so that the wheelchair responds, brakes and
accelerates the same in these profi les as before any changes.
!
WARNING
The braking distance of the inside and outside profi les is preset to brake
from 10 to 0 km / h in less than 2.1 m. If this parameter is modifi ed, it is
also necessary to modify the Forward Declaration parameters in order to
not exceed the maximum braking distance.
!
WARNING
Do not exceed 70 m / ohms at the risk of overheating the motors.
Made by:
Amylior Inc.
3190 F.X. Tessier - Vaudreuil-Dorion, QC - J7V 5V5 - Canada
Téléphone : +1 450-424-0288 - Email : info@amylior.com
Designed and distributed by:
Logo Silver
32 rue de Comboire - 38130 Echirolles - France
Téléphone : +33 4 76 21 22 19 - Email : contact@logo-silver.fr