Astria Fireplaces ODYSSEY 36 Series Product information

  • Hello! I am an AI chatbot trained to assist you with the Astria Fireplaces ODYSSEY 36 Series Product information. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page 1 of 2
ODYSSEY™ 36/42 SERIES
P/N 900698-00, REV. A, 11/2016
Fireplace Dimensions
OUTDOOR VENT-FREE GAS FIREPLACE
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Models A B C
36” Models
42-3/4”
(1086 mm)
44”
(1118 mm)
21”
(534 mm)
42” Models
46-1/2”
(1181 mm)
51”
(1296 mm)
23”
(585 mm)
Models D E F
36” Models
44”
(1118 mm)
74”
(1880 mm)
52”
(1321 mm)
42” Models
51”
(1296 mm)
86”
(2185 mm)
61”
(1550 mm)
Framing Dimensions
Diagrams, illustrations and photographs
are not to scale. Consult installation
instructions. Product designs, materials,
dimensions, specifications, colors,
and prices are subject to change or
discontinuance without notice.
C
B
A
D
F
E
36”
Model
42”
Model
A
29”
(737 mm)
36”
(915 mm)
B
41”
(1042 mm)
48”
(1220 mm)
C
43”
(1093 mm)
50”
(1270 mm)
D
37”
(940 mm)
41”
(1042 mm)
E
41”
(1042 mm)
45”
(1143 mm)
F
21”
(534 mm)
24”
(610 mm)
G
35”
(889 mm)
42”
(1067 mm)
H
10-1/2”
(267 mm)
10-1/4”
(261 mm)
J
14-1/2”
(369 mm)
16-1/2”
(419 mm)
K
21”
(534 mm)
23”
(584 mm)
Right
Side
View
Left
Side
View
Fireplace Top View
Front View
A
B
C
D
E
F
G
H
4-1/2
(115)
9-1/4
(235)
3-1/2
(89)
13-1/2
(343)
Electrical
Access
Hole
J
K
9-1/4
(235)
3-1/2 (89)
4 (102)
13-1/2
(343)
5/8
(16)
DRAF
T
Printed in U.S.A. © 2016 Innovative Hearth Products
P/N 900698-00 REV. A 11/2016
Page 2 of 2
Specifications and clearances are subject to change without
notice. Refer to Installation Manual before installation of
these appliances for updated dimensions and instructions.
ClearancesFacing
ODYSSEY™ 36/42 SERIES
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Minimum Wall and Ceiling Clearances (see figure below)
A. Clearances from the side of the fireplace cabinet to any combustible
material and wall should follow diagram shown here.
Example: The face of a mantel, bookshelf, etc. is made of combustible
material and protrudes 3-1/2” from the wall. This combustible mate-
rial must be 4” from the side of the fireplace cabinet.
B. Clearances from the top of the firebox opening to the ceiling should
not be less than 42”.
C. When the firebox is installed directly on carpeting, vinyl tile or other
combustible material, other than wood flooring, the firebox should be
installed on a metal or wood panel extending the full width and depth
of the enclosure.
D. Clearances from the bottom of firebox to the floor is 0”.
12-1/4 (312)
10-1/2 (267)
8-3/4 (223)
7 (178)
5-1/4 (134)
3-1/2 (89)
1-3/4 (45)
7/8 (23)
1/2 (13)
1/2
(13)
1
(26)
2
(51)
4
(102)
6
(153)
8
(204)
10
(254)
12
(305)
14
(356)
16
(407)
Example
Inch (millimeter)
Product Information
Listing Information
These appliances comply with National Safety
Standards and are listed by PFS Corporation
to ANSI Z21.11.2 as unvented Gas-fired
room heaters.
PFS
®
USC
Report No. F09-026
Cat. No. Model Liner Weight Cu. Ft.
F0584 Odyssey36ZNM WS 237 lb. 23.4
F0585 Odyssey36ZPM WS 237 lb. 23.4
F0586 Odyssey36ZNM WH 237 lb. 23.4
F0587 Odyssey36ZPM WH 237 lb. 23.4
F0588 Odyssey36ZNM RS 237 lb. 23.4
F0589 Odyssey36ZPM RS 237 lb. 23.4
F0590 Odyssey36ZNM RH 237 lb. 23.4
F0591 Odyssey36ZPM RH 237 lb. 23.4
Cat. No. Model Liner Weight Cu. Ft.
F0592 Odyssey42ZNM WS 312 lb. 34.3
F0593 Odyssey42ZPM WS 312 lb. 34.3
F0594 Odyssey42ZNM WH 312 lb. 34.3
F0595 Odyssey42ZPM WH 312 lb. 34.3
F0596 Odyssey42ZNM RS 312 lb. 34.3
F0597 Odyssey42ZPM RS 312 lb. 34.3
F0598 Odyssey42ZNM RH 312 lb. 34.3
F0599 Odyssey42ZPM RH 312 lb. 34.3
OUTDOOR VENT-FREE GAS FIREPLACE
Supplied
Firebox Hood
Must Be Used
at All Times
Wire-mesh
Screen
Firebox
Noncombustible
Material May
Project Off this
Surface above
the Firebox Hood
Mantel Shelf
Note: Any portion of the
mantel shelf must NOT
extend beyond this profile.
1-1/2 (38)
6-3/4 (172)
12 (305)
Note: All vertical
measurements are
from top of fireplace
hood opening to
bottom of mantel shelf.
These minimum
clearances replace any
other recommended
clearances supplied
with your ANSI Z21.11.2
approved gas logs.
Wall board or facing
material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments or
other similar projec-
tions off of the facing
material.
Framing
Material
20
(508)
16
(407)
12
(305)
Inch (millimeter)
Facing material above
firebox must be of
noncombustible material.
A 12” concrete board
projecting the width of
the fireplace is supplied.
Hood MUST
be used if a
combustible
mantel is
installed.
NOTE: All vertical
measurements are from
top of fireplace hood
opening to bottom of
mantel shelf.
12’’ minimum noncombustible
wall board or facing materials on
sides.
12’’ minimum noncombustible
wall board or facing material
above fireplace.
Combustible materials
not allowed adjacent to
fireplace.
Steel Stud or Steel
Framing Required.
/