11
D Note:
Ifthewatersupplystopswhilethe
appliancedispensesinmanualmode,the
purewaterdispenserswitchestoAUTO
mode f.
Ifyouwanttoprogramthepurewater
dispenser to dispense at a later time
(whenwatersupplyresumes),pressthe
LITRESbuttontosetawaterquantity.
The display shows the set quantity.
The pure water dispenser is now ready
to dispense the set quantity automatically
once the water supply resumes.
6.0.2 Purifying in AUTO mode
1 Pressthepower-onbuttononthepure
water dispenser. Wait until the dispense
button
dashes.
2 PresstheMODEbutton
The pure water dispenser goes into AUTO
mode f.
The dispense button
d goes out and
thedisplayashes.
3 PresstheLITRESbuttontosetthedesired
water quantity.
increases by 0.2 litres each time you press the
button.
Once you have set the quantity, the dispense
button dashes.
4 Pressthedispensebuttond
Theappliancedispensespuriedwater.
The display counts down as the water is
dispensed (i.e. the display shows the amount
of water still to be dispensed).
The pure water dispenser automatically
stops when it has dispensed the set quantity.
The display retains the previously set
quantitysothatyoucanllmultiple
containers of the same capacity.
To cancel/reset the existing setting, either
mode) or press the power-on button to
switch off the dispenser.
•
•
•
•
•
•
•
•
•
•
6 Using the appliance
1 Openthetapconnectedtothepurewater
dispenser.
2 Whenyouusetheappliancefortherst
timeorifyouhavenotusedtheappliance
for2daysormore,usethePureFlush
function.Seesection‘PureFlush’inthis
chapter.
6.0.1 Purifying in manual mode
1 Pressthepower-onbuttononthepure
water dispenser
Allindicatorsashonandoff.
The power-on indicator y goes on.
The display goes on.
WP3893 only: If mains power is available,
the battery indicator
z lights up green.
If there is no mains power available, the
battery indicator lights up red. During
charging,thebatteryindicatorashes
green. When the battery is almost empty,
thebatteryindicatorashesred.
The pure water dispenser checks the water
availability,thelterandtheUVlamp.
Asthepuricationprocessproceeds,rst
theredsegmentofthepuricationstage
indicator e lights up, followed by the yellow
segment.Whenthepuricationprocess
isnished(after30seconds),thegreen
segment lights up.
The dispense button dashes(default
mode= manual).
2 Pressthedispensebuttond
The pure water dispenser dispenses water.
The display shows the quantity of dispensed
water and the dispense button lights up
green.
3 Tostopthewaterow,pressthedispense
button
d again.
Thedispensebuttonashesandthe
appliance is ready to dispense again.
•
•
•
•
•
•
•
•
•
ENGLISH