Powerfist 9032202 Owner's manual

SPECIFICATIONS

HAZARD DEFINITIONS

INTRODUCTION

SAFETY

WARNING! Read and understand all instructions before

using this tool. The operator must follow basic

precautions to reduce the risk of personal injury

and/or damage to the equipment.

WORK AREA

PERSONAL SAFETY

WARNING! Some dust created by power tools may

contain lead, crystalline silica, arsenic and chromium,

which are known cause cancer, birth defects or other

reproductive harm. Ensure work area is well ventilated

and always wear recommended personal protective

equipment.

WARNING! Wear personal protective equipment

approved by the Canadian Standards Association (CSA)

or American National Standards Institute (ANSI).

PERSONAL PROTECTIVE EQUIPMENT

PERSONAL PRECAUTIONS

SPECIFIC SAFETY PRECAUTIONS

WARNING! DO NOT let comfort or familiarity with

product (gained from repeated use) replace strict

adherence to the tool safety rules. If you use this tool

unsafely or incorrectly, you can suffer serious personal

injury.

POWER TOOL PRECAUTIONS

ELECTRICAL SAFETY

WARNING! Do not touch or handle a live tool with any

part of your body that is wet or damp. Wet skin

reduces resistance to electrical current, increasing

the danger of a serious or fatal shock.

WARNING! To reduce risk of electric shock, be certain

that the plug is connected to a properly grounded

receptacle.

WARNING! Do not let your fingers touch the terminals

or plug when installing ot removing from the outlet.

UNPACKING

WARNING! Do not operate the tool if any part is

missing. Replace the missing part before operating.

Failure to do so could

result in a malfunction and

personal injury.

ASSEMBLY & INSTALLATION

MOUNTING THE DUST CHUTE

MOUNTING THE DISC TABLE

MOUNTING THE BELT TABLE

DUST PORT

BACKSTOP

MOUNTING TO A SURFACE

OPERATION



ADJUSTING THE DISC TABLE

ADJUSTING THE BELT TABLE

SURFACE SANDING

END SANDING

CONTOUR SANDING

USING THE MITRE GAUGE

CARE & MAINTENANCE

WARNING! Always unplug the tool before performing

any inspections or maintenance.

WARNING! Only qualified service personnel should

repair the tool. An improperly repaired tool may

present a hazard to the user and/or others.

ABRASIVE BELT REPLACEMENT

ABRASIVE DISC REPLACEMENT

ADJUSTING ABRASIVE BELT TRACKING

CLEANING

WARNING! Clean the dust collector and guards before

using tool for any metal grinding purposes. Sparks can

potentially ignite debris and start fires.

WARNING! Never use highly volatile solvents. Avoid

getting cleaning solution on paint as it tends to

deteriorate these finishes. Use soap and water on

painted components.

LUBRICATION

NOTICE! NEVER use a penetrating oil to lubricate the

tool. Penetrating oil may act as a solvent that can

break down the grease and cause the tool to seize up.

DISPOSAL

IMPORTANT! DO NOT pollute the environment by

allowing uncontrolled discharge of waste oil.

TROUBLESHOOTING

Problem(s)

Possible Cause(s)

Suggested

Solution(s)

Page is loading ...

Powerfist 9032202 Owner's manual

Powerfist 9032202 Owner's manual

in other languages

Related papers

Other documents