Tappan Twinning Kit for Air Handler Installation guide

Tappan
Brand
Tappan
Model
Twinning Kit for Air Handler
Category
Thermostats
Type
Installation guide
2 - 5 Ton Air Handler Twinning Instructions - Commercial Split Systems
INTRODUCTION
These instructions are primarily intended to assist qualified individuals experienced in the proper installation of heating
and/or air conditioning appliances. Before beginning the installation, read these instructions thoroughly and follow all
warnings and cautions in the instructions and on the unit. Improper installation, service, adjustment, or maintenance
can cause explosion, fire, electrical shock, or other conditions which may result in personal injury or property damage.
Installation Instructions
These instructions are to be used when connecting two
2 - 5 Ton (B3 style) Air Handlers to a common single stage
A/C condensing unit or heat pump.
ELECTRICAL WIRING
General – Electrical power wiring must be made in
accordance with all applicable local codes and ordinances,
and with the current revision of the National Electrical Code
(ANSI/NFPA 70). If any of the original wire as supplied with
the unit must be replaced, it must be replaced with wire
material having the same gauge and temperature rating.
Line Voltage – See the air handler unit wiring label/
instructions for proper high voltage wiring. Use separate
branch electrical circuits for each air handler.
Low Voltage – All low voltage wiring instructions, cautions,
and warnings accompanying the air handler remain
applicable, except for:
1. Both air handler’s 24V transformers must be removed
from the control circuit by removing and discarding the
RED wire located on the transformer’s secondary. The
S3BM series A/C outdoor units come standard with
24V power supply sufficient for powering both air
handlers.
2. Low voltage wiring should be connected as shown in
Figure 1.
3. The thermostat used must be configured to bring fan
“ON” (energize “G”) with a call for HEAT.
4. For 2 - 5 Ton (B3 style) air handlers equipped with a
printed circuit board control, 24V (R) must be connected
to both indoor units.
REFRIGERANT PIPING
The refrigerant piping to each air handler (or coil) should be
of equal length and size. Run the copper pipes from
condensing unit to a point equidistant between the air
handlers (or coils). Place a tee in the lines at this point. After
the tee, as close to the air handler as practical, reduce the
pipe size to match the piping of the air handler or coil.
Figure 1. Low Voltage Wiring
Note: *See #3 above.
Y
R
C
Outdoor
Unit
A/H #1
C R G W
W
G
Y
R
Thermostat*
1
¢707973J¤
707973D
O’Fallon, MO
707973D (Replaces 707973C)
Specifications and illustrations subject to change
without notice and without incurring obligations.
Printed in U.S.A. (05/03)
A/H #2
C R G W
1
See #4 above.
  • Page 1 1

Tappan Twinning Kit for Air Handler Installation guide

Tappan
Brand
Tappan
Model
Twinning Kit for Air Handler
Category
Thermostats
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents