Jenn-Air JFC2290VPF1 Installation guide

Type
Installation guide

This manual is also suitable for

Decorator Panel mensions an Installation.
A
mi
= B
D
B
C
Suggested Panel Assembly Methods
A
B
C
D
Thickness
B
17-3/4"
(451mm)
44-1/8"
(1121mm)
24"
(610mm)
35-3/4"
(908mm)
3/4" max
(19mm)
16-3/4"
(425mm)
43-3/16"
(1097mm)
23"
(584mm)
34-3/4"
(883mm)
1/16"
(2mm)
17-3/8"
(441mm)
43-13/16"
(1113mm)
23-9/16"
(599mm)
35-5/16"
(897mm)
1/4"
(6mm)
* For ease of installation cut backer panel corners at
45o_ 1,,x 1,,
1" (25.4mm)
Typ.
I I
WEIGHT REQUIREMENTS FOR PANEL INSERTS
individualrefrigerator door panels should not exceed 15 Ibs. (7 kg).
Freezer drawer panel should not exceed 15 Ibs. (7 kg).
Three Panel Method
Trim Frame
Surrounding Door
Refrigerator Door
Front Panel ( 3/4" Max.)
Spacer Panel (1/16")
Backing Panel (1/4")
Routed Raised Panel Method
Trim Frame
Surrounding Door
Routed Area
Front Panel ( 3/4" Max.)
i ]
+
Backing Panel (1/4")
12884405 06/08
Decorator Panel Installation
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
1. Lift upper locking trim from the door.
0
Backing Panel
Spacer Panel
Trim
Front Panel
Door
Door Panel
Installation common with all panels.
NOTE: Consult your cabinetmaker for creation
of decorator panels. Customer to provide own
handles.
2. Remove side trim from either side of door.
Remove backing from adhesive tape.
See user guide for door removal if necessary.
NOTE: For ease of assembly and to familiarize
yourself with the installation process, add the
custom panel to the lower freezer drawer first.
Before removing backing from adhesive
tape assure the decorator panel fits the
door.
o O
3. Align the bottom edge of the decorator panel
to the lower fixed trim and center the panel with
the door.
Front
Panel
7. Align the upper locking trim with the clips on
top of the side trim.
StDE TRtM
CLIP
I
\
4. Assure the side trim clip locates to the inside
corner of the lower fixed trim.
SIDE
CLIP
8. Assure the upper locking trim grooves
engage the rivets on the door panel while
simultaneously seating into the decorator
panel groove.
9. Apply firm pressure to the upper locking
trim to hold panel in place.
5. Rotate one piece of the side trim to seat into
the decorator panel groove.
6. Repeat procedure for opposite side of door.
10. Fully seated top trim is close to flush with top
of door and completely covers clips of side trim.
\
/
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Jenn-Air JFC2290VPF1 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI