Ames CS1 User manual

Type
User manual

This manual is also suitable for

PHYSICAL PERFORMANCE PROPERTIES
SPECIFIC
HAZARD
FLAMMABILITY
HMIS
REACTIVITY
HEALTH
HAZARD
0
0
1
Appearance (cured).........................
Appearance (liquid).........................
Color................................................
Mildew Resistance..........................
Weight.............................................
Solvent............................................
Odor................................................
Permeability....................................
Elongation.......................................
Strength..........................................
Viscosity..........................................
PH as Shipped................................
Specific Gravity...............................
Bonding...........................................
Humidity..........................................
Freeze/Thaw Stability Test
of Dried Materials............................
Setting Time....................................
Cure Time.......................................
Material Composition......................
Toxicity............................................
Flash Point......................................
Fire Rating.......................................
Tukon Hardness(KHN)....................
Semi-clear, satin finish
Clear
Excellent
8.64 lbs/gal
Water
Mild
Up to 300%
75 + 25 cps, #2/100 rpm (Brookfield Model DV-1+)
9.0 - 10.0
Best applied at when humidity level is below 50%
If frozen while in liquid form, may be damaged or solidify. Protect from freezing
2-8 hours drying time between coats. Drying time dependent on weather
and humidity.
Slight tack until cured.
Non-toxic after curing
1500°F. (estimated)
Class “A” ASTM R-108. over AC.ASTM E-84 zero smoke
Coverage Rate................................ Approximately 200 sq. ft. per gallon, depending on surface characteristics.
Voc Content.................................... Less than 1 gram per liter.
Formulas have been tested in accordance with ASTM E 108 E-108 Class “A” over AC.ASTM E-84 zero smoke, zero
ignition. Important: Apply a small amount to ensure the product performs satisfactorily.
022018
Ames Research Laboratories, Inc., 1891 16th St. SE Salem, OR 97302 USA
Toll-Free: 1-888-345-0809 | Phone:503-588-3330 | Fax: 503-364-2380 | www.amesresearch.com | productservices@amesresearch.com
AMES
®
CLEAR SEAL
Ames Clear Seal is a unique, semi-clear elastomeric plastic sealant and adhesive for
wood and concrete. It penetrates deeply into wood and concrete to actually glue and bind
together the molecules of the surface it is being applied to. Rotting and deteriorating
surfaces can be restored to a somewhat new condition and often the surface life can be
extended for one or more years of usefulness. Clear Seal helps preserve wood from
mildew and moss formation, stops concrete efflorescence and helps to prevent rust from
penetrating metal. Clear Seal is VOC- free, has low odor and cleans up with water.
  • Page 1 1

Ames CS1 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI