Stanwood Needlecraft YBW-A User guide

Brand: Stanwood Needlecraft

Model: YBW-A

Type: User guide

Instructions to Use Yarn Ball Winder YBW-A

Clamp the

ball winder

tightly to a

sturdy table.

Unwind a hank of

yarn and mount it

on a swift winder,

or other devises

(your helper’s

arms).

Thread the yarn through the

wire arm and then tightly into

the cleft of the bobbin. Be

sure the yarn does not slip.

Begin turning the crank on the

ball winder clockwise to start

winding.

www.stanwoodimports.com

stanwoodimports@yahoo.com

Tel: (310)962-9184

All Rights Reserved 2012

To set up the

wire arm, rotate

the arm leftward

and force it through

the bump as shown

to lock it in.

Align the bobbin to

its base as shown.

Lock it by pushing

down and turning

counter clockwise.

Slide the yarn

ball out of the

bobbin. Pull the

lead from the

center of the ball.

Bump

Align

1

Stanwood Needlecraft YBW-A User guide

Brand: Stanwood Needlecraft

Model: YBW-A

Type: User guide

Other documents