2. Stanwood Needlecraft
  3. YBW-A

Stanwood Needlecraft YBW-A User guide

  • Hello! I am an AI chatbot trained to assist you with the Stanwood Needlecraft YBW-A User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Instructions to Use Yarn Ball Winder YBW-A
Clamp the
ball winder
tightly to a
sturdy table.
Unwind a hank of
yarn and mount it
on a swift winder,
or other devises
(your helper’s
arms).
Thread the yarn through the
wire arm and then tightly into
the cleft of the bobbin. Be
sure the yarn does not slip.
Begin turning the crank on the
ball winder clockwise to start
winding.
www.stanwoodimports.com
stanwoodimports@yahoo.com
Tel: (310)962-9184
All Rights Reserved 2012
To set up the
wire arm, rotate
the arm leftward
and force it through
the bump as shown
to lock it in.
Align the bobbin to
its base as shown.
Lock it by pushing
down and turning
counter clockwise.
Slide the yarn
ball out of the
bobbin. Pull the
lead from the
center of the ball.
Bump
Align
/