Peavey Patching Adapter Owner's manual

The Patching Adapter

™

includes (6) 1/4" phone jacks in parallel. This unit can be one

of the most useful “tools” available for patching systems together when “Y”

connectors are needed.

Actually, the Patching Adapter is a six-way “Y” connector which may be used for

channel grouping of submasters or for any situation calling for paralleling of several

different signals.

Be careful when paralleling outputs from mixers, effects devices, etc., because not all

manufacturers provide “build - out resistors” which allow those outputs to be mixed.

Several speaker enclosures may be connected to one power amp with the Patching

Adapter, but total system impedance should be considered. Speaker cables (not

shielded patch cables) should be used for speaker level. Shielded cables should be

used for all low level patching.

CCaauuttiioonn:: NNeevveerr ppaarraalllleell tthhee ssppeeaakkeerr oouuttppuuttss ffrroomm ppoowweerr aammppss wwiitthh

tthhee PPaattcchhiinngg AAddaapptteerr oorr bbyy aannyy ootthheerr mmeeaannss..

SSPPEECCIIFFIICCAATTIIOONNSS PPaattcchhiinngg AAddaapptteerr

™™

Features and specifications subject to change without notice.

Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com

80303112