1
2. Remove operating instructions,
manufacture statement of origin,and
owners manual located on top of ATV.
1. Remove cardboard carton from
metal frame
E - REV - A
Set-up Instructions WD90U/CN90U
2
3. Remove bolts as indicated in photo
from both sides of metal frame
4. Carefully remove metal
frame
5. Remove wire straps from front bumper 6. Remove wire straps from rear axle.
Removal from crate
3
7. Loosen plastic guard bolt and remove
plastic guard.
8. Loosen all bolts and lift handle bars to
desired position, tighten handle bar bolt.
Torque to 25Nm (18.5ft.lb). Replace the
plastic guard and tighten bolt.
Handlebar Assembly
4
Flag pole Assembly
9. Remove nut from ag
holder assembly.
10. Attach ag holder assembly to mounting
bracket on rear rack of ATV and tighten nut.
11. Insert ag pole into ag holder assembly.
Mounting bracket
Flag holder assembly
Nut
Nut
Flag holder assembly
5
12. Refer to battery section of owners manaul for
correct installation and charging of battery.
Battery is located under the seat
Battery Installation
6
Oil Cap
!!WARNING!!
This engine may be shipped with pack-
ing oil in it. This oil should be drained and
replaced with new oil as described in the
owners manual. Never attempt to start
engine without rst replacing the engine
oil with the proper amount and grade as
described in the owners manual.
10. Fill engine with correct amount of oil. Refer to
owners manual for oiltype and quantity.
11. Fill gas tank as specied in
owners manual.
Gas Cap
12. Refer to owners manual for proper
starting instructions.
Gas and Oil
/
