Spin Master Ltd., 450 Front St. W. Toronto ON M5V 1B6 Canada
1-800-622-8339 www.spinmaster.com
MADE IN CHINA. Water Slide IS Generic US English Rev 2 Jan. 19, 2005
STORAGE, CARE AND MAINTENANCE
The key to longevity is proper care and cleaning of the slide. A non-detergent cleaner such as
Ivory
TM
bar soap, not dish washing liquid! Can remove most stains. For stubborn stains or mold,
Clorox
TM
is recommended. Specifically, one (1) part Clorox
TM
to nine (9) parts water.
1. Water Slide Unit is made of all new material.
2. Never store the Water Slide unit when wet. Allow to dry before rolling up.
3. Store the Water Slide unit and the fan in a dry place. Never leave either the Water Slide unit or the fan
outside in the rain or elements when not in use.
4. Do not immerse fan in water. Wipe clean with a damp cloth.
(Refer to fan instructions for fan maintenance).
CAUTION: ELECTRICALLY OPERATED PRODUCT
NOT RECOMMENDED FOR CHILDREN UNDER 3 YEARS OF AGE. AS WITH ALL ELECTRIC
PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO
PREVENT ELECTRIC SHOCK. ADULT SUPERVISION REQUIRED.
CALL CUSTOMER CARE
at 1-800-622-8339
or visit www.spinmaster.com
DO NOT RETURN TO STORE!
TO DEFLATE AND STORE THE SLIDE
ATTENTION: Never store the Water Slide unit
when wet. Always dry before rolling up and
storing.
1. Remove all children from the Water Slide unit.
2. Turn water spray off and remove hose assembly.
Carefully store hose assembly to avoid kinking.
3. Let fan run until unit is dry.
4. Remove all accessories from inside the Water
Slide unit and be sure it is free of any debris
or objects.
5. Turn off the fan (Refer to fan instructions for fan
operation).
6. Disconnect the intake tube from the fan, and
open the release tube*.
7. Allow the Water Slide unit to deflate completely.
It should deflate on its own within 5 minutes.
8. Check the unit for wet spots and let the unit dry
before storing the product.
9. Fold slide in half, by bringing pool end of unit up
over the other end of slide. Fold it in half 2 more
times or until unit is approximately as wide as
the storage bag.
10. Roll it up tightly starting from the end opposite
from the intake tube.
11. Slip storage bag over the rolled-up Water
Slide unit.
12. Flip the bag and
zip it closed.
*Not with all models.
TM
SEE THE
DVD
INCLUDED
OR VIEW IT AT
www.spinmaster.com
Please read the separate fan instructions before setting up the
water slide. (Fan instructions are included with fan).
Fold 1
Fold 2
Fold 3
Fold 4
Fold 5
Roll
WARNING:
Failure to follow these instructions could result in serious injury or death.
• Set up: By adults only. • During use: Adult supervision at all times. • Make sure grass is free from debris. • Use stakes to
anchor to level ground and periodically check anchors are firmly staked. • Set up as close to power source as possible.
FOR PERSONAL HOME USE ONLY. Not intended for commercial and/or public use. (E.g. as a party rental product or for use in a gymnasium/
school). Water Slide products are not designed for commercial and/or public use.
• Do not place or drag on concrete or pavement or other rough surfaces. Must be used on a grass surface.
• This unit has been purposely designed to allow air flow through its seams in order to achieve proper operation.
Do not attempt to seal as some air must be allowed to escape from the unit.
• Assure the fan is in dry location while in use. Keep the fan away from
water source.
• Never slide head first, always slide feet first and make sure the slide is
clear of people before sliding down.
• Never stand on, pushing or jump from top slide platform.
• Never leave children unattended. Keep infants away from pool!
DROWING HAZARD! There is no substitute for constant adult supervision.
Most drowning occurs during a five minute or less lapse in supervision,
child can drown in as little as two inches (5 cm) of water.
• Examine periodically for potentially unsafe conditions such as a damaged
cord, plug, housing, parts or anchor loops. If damage is found, do NOT
use until properly repaired.
• Watch your step when entering or exiting the Water slide unit.
• Keep all flame and heat sources away from this fabric. It is not fire proof.
The fabric will burn if left in continuous contact with any flame source.
• Children should not use Water Slide unit if they currently have, or have
experienced, any of the following: neck or back injuries; respiratory
conditions, such as asthma or bronchitis; chronic knee or other joint
conditions; or any cardiac or circulatory problems.
• Read and follow instructions in Instruction Manual.
DO NOT:
• Leave Water Slide unit or Fan outside in rain or elements
when not in use.
• Set up close to water, walls and other obstructions.
• Jump on to or off of Water Slide unit.
• Play with unevenly matched children. (Weight & height)
• Grab onto the net.
• Set up when very windy.
• Allow children near the fan.
• Leave children unattended in the Water Slide unit
at any time.
• Setup close to traffic area.
• Use an extension cord to plug in fan.
No Rough Play
No Glasses
No Shoes
Max Number of Children
Total Weight Limit
No Jewelry
Max Individual Height
No Sharp Objects
Max Individual Weight
Age
3
+
No Extension Cords
SLIDE
INSTRUCTION
MANUAL
INSTRUCTIONS FOR SET UP
WARNING: Adult Set Up and Supervision Required.
The Bounce ’Round
TM
unit should be inflated or deflated only by an adult.
1. Make sure there are no pipelines or utilities under the ground before
entering stakes. Unfold the un-inflated Water Slide unit on a grassy,
level surface that is free of glass, rocks or other debris
that can cause injury. Make sure the Water Slide unit
is free from overhead power lines and obstructions.
2. Fill water bags* and attach to side of slide
(B).
(Water bags must be used so the slide will fully
inflate. Never allow children to play on slide without
installing water bags.) Anchor all hold-downs to the
ground with the stakes provided. Angle stakes at a
45° angle away from unit (A). Periodically check while
in use. Make sure Water Slide unit is at least
10 ft (3 m) away from other structures.
*Note: Not all slides require water bags.
Use on grass only. Do not drag or use on concrete.
3. Place fan unit away from water spray and ensure that water does not flow towards the fan. If water
contacts fan, disconnect power cord from wall plug. Do not resume operation until fan is completely dry.
4. Tie the long intake tube on the Water Slide unit around the mouth of the fan with the provided
drawstring (C).
5. Tie the short release tube closed (if any), with the provided drawstring (D).
6. Make sure the intake tube has no kinks or folds and that the slide unit is securely anchored.
Failure to take these precautions could
result in injury during play.
7. Make sure that the fan switch is in
the “OFF” position. Plug the fan into
a properly grounded 110v outlet
(See Grounding Instructions in Fan
Instruction Sheet).
8. To inflate the slide unit, (press the reset
button on GFCI) move the fan switch
to the “ON” position. It should inflate in
approximately 2 minutes.
9. Locate the spray hose attachment at
top of slide.
INSTRUCTIONS FOR SET UP continued
10. Deflate the unit so you can attach the hose assembly.
Attach the sprayer nozzles first (E) then attach
the hose across the top of the unit and down the side
of the slide with the (Hook & Loop) attachment tabs (F).
11. For model #’s 61657 and 61460 ONLY, add the slide
extension to the end of the slide using the hook and
loop fastener (G).
12. Turn the blower back on to fully inflate the unit.
13. Adjust position of fan to ensure there are no kinks or folds
in the tube before staking fan down into its final position
(H). Always make sure Water Slide fan is securely
anchored to the
ground with the
stakes provided.
14. Attach the garden
hose and turn
spray unit on and
begin play (I).
WARNING:
Do not allow children to play in the Water
Slide unit until it is fully inflated. Never let
children near the electric blower at any time.
15. After the Water Slide unit is fully inflated, leave the fan running during play.
AIR FLOW THROUGH SEAMS IS NORMAL. Do not try to seal seams.
16. To deflate the slide unit, move the fan switch to the “OFF” position.
WARNING: Remove all children from the Water Slide unit before deflating.
OPERATION TIPS
• Prohibit roughhousing by occupants.
• Keep clean and dry between uses.
• If there is any deflation occurring, ask the people in the Water Slide Unit to sit down and then unload
them in a calm and orderly manner.
• Keep all food, drinks, snacks and gum away from the Water Slide unit.
• Keep all toys, party favors and silly string away from the Water Slide unit.
• Consult the Weight/Height Chart on page 2 or on your Water Slide unit to see maximum loads for
individual rides. Do not exceed these requirements.
• Make sure all stakes are planted firmly in the ground and check them regularly to make sure
they are secure.
• Do not inflate the unit in high winds (12.4 mph/20 kph), rain, or low temperatures (41°F/5°C).
• To reduce the risk of fire or electrical shock, do not expose the blower to water or rain.
• Do not use the fan in conditions of rainfall. Unplug the GFCI plug from power source.
• Use the TEAR-AID
TM
patch (included) to fix holes in your Water Slide unit by cutting patch to size,
peeling off adhesive backing, and leaving for 24 hours to dry.
A
STAKE
SHORT RELEASE
(NOTE: Not with all models.)
INTAKE TUBE
FAN
B
C
D
E
F
H
I
Water
Bag
Model #
Max #
of Kids
Total Weight
(Limit lbs/kg)
Maximum
Individual
Weight (lbs/kg)
Slide
Max
Height/
Child (ft/m)
Fan
Storage
Bag
Water
Bags
Ride-
On
61460
Fan
Stakes
Slide
Add-On
Hose
Sprayer
Assembly
Slide
Stakes
200/91 100/45
11
1
5/1.5
5/1.5
5/1.5
5/1.5
100/45 100/45
11
1
61562
200/91 100/45
11
1
61578
61657
100/45 100/45
1
1
1
0
0
1
1
1
11
4
4
4
4
TBD
TBD
TBD
TBD
2
2
0
2
2
0
0
0
1
CONTENTS
G
OR
#61657 #61460
/
