Steam Milk-Frothing Function
1. When the " Steam button " is selected, the light starts flashing, until the indicator light changes from
flashing into being on always; then the pre-heating is finished.
2. Pour the iced whole milk of 1/3 in the garland cup, insert the steam nozzle into the 1CM-deep milk
surface, and then slowly unscrew the " Steam knob " until the steam sprays out.
Note: The size of the steam can be adjusted according to personal proficiency. A little water in the steam
pipe shall be released before the milk frothing.
3. When the milk temperature reaches about 75 degrees, the milk froth starts to expand; then turn off the
" Steam knob " and the " Steam button " .
Note: After the milk froth is finished, clean the milk on the surface of the steam jacket with a damp cloth
timely, and spray out the steam again for 5s to prevent the milk from being dried up so it doesn’t block the
steam outlet.
4. Turn off the " On / Off button " finally.
5. Then shake the garland cup on the table to fully melt the milk froth, and then pour it into the coffee cup.
Note: Cocoa powder / chocolate cream can be sprinkled on the coffee according to personal preference;
additionally, various fancy utensils can be used in making a cup of your favorite Italian fancy coffee.
Note: When milk foaming is complete and you want to make another cup of espresso, please don’t remove
the metal funnel immediately, it may cause coffee grounds to splash. So make sure the coffee machine is
completely cooled before using. In order to cool down the coffee machine properly, we suggest to proceed
“ Hot Water Function ” .
Hot Water Function
1. After the " On / Off button " is selected, other button lights flash, and the coffee maker starts
pre-heating; after the pre-heating is finished, the button light is always on; press the " Manual control
button " and turn on the " Steam knob ", until the steam nozzle discharges hot water. The hot water can be
used for drinking, cleaning or heating cups.
2. After completion, turn off the " Steam knob " to " OFF " , and then press the " Steam button " .
3. Turn off the " On / Off button " finally.
Coffee Brewing Time Setting Function
Under the status that the pre-heating has been finished, press and hold the " single-cup or double-cup
coffee button " for three seconds to make the coffee maker beep three times; when the coffee in the cup
reaches the required set amount, press the " Single-cup or double-cup coffee button" to make the coffee
maker beep three times; at this time, the time memory function is set. Coffee discharging time is set
between 8-60 seconds; otherwise the setting is failed. The next coffee discharging time will follow the last
set value.