Kensington H1000 USB-C On-Ear Headset installation guide.
Register your headset at kensington.com/register
1. To connect the headset to your device, plug the headset cable into any available USB-C port.
2. Adjust your headset for optimal comfort and performance. Adjust the headband on both sides so the earpads rest comfortably on your ears.
Adjust the rotating microphone so it is directly in front of your mouth. The microphone can be worn on the right or left side.
3. Adjust your volume for comfortable listening. Locate the buttons on the side of the in-line controls. Press the "+" button to increase the volume and the "-" button to decrease the volume.
4. Use your in-line controls to maximize your productivity.
Busy Light: The busy light will automatically illuminate when the microphone is activated.
You may also manually turn the busy light on and off.
Pressing the button once will cause the LED to manually illuminate as a solid red LED light.
Pressing and holding it for 2 seconds will cause the red LED light to pulse/blink.
Pressing it again in either status (solid or pulse) will cause the LED to be manually turned off.
Mute: Press the mute button to mute your microphone. It will illuminate red when your microphone is muted. Press the button again to unmute your microphone.
Play/Pause: Use the play/pause button to control your music or podcasts between calls.
For support, visit kensington.com/support
/