Page is loading ...
User Manual
1. Main technical specifications:
Voltage: DC3V
Working Current: ≤18mA
Quiescent Current: ≤3uA
Transmission Frequency: 315MHZ
Type of Modulation: ASK
2. How to use:
1). Learning Explanation:
---Press ON/OFF button of remote and hold 3 seconds to start. (Need keep pressing the button for 3 seconds.) The
lamp will light. Another 3 seconds press for shut off or it’ll be off together with the lamp after 2 mins if there is no
operation at all.
2). Clear and Study Status:
---Press both remote “IN & OUT” button for 20 seconds when the receiver and remote are both opened to clear
the learning status. Lamp will turn to light from flashing.
---Then press both “IN & OUT” button 3 seconds for learning. When the light turns to light from off, it means it’s
learnt successfully. Now you can operate the “IN&OUT” button to control the motor.
---Clear and Learn function only can be operated in 2 mins time. If your operation process exceeds 2 mins, the
remote will turn to auto-off status. Then you need to progress above process again.
3.Interference: During operation, it may be disturbed according to actual environment, so the remote distance
may also change.
3. Notes：
Do not let remote control suffer violent vibration. Do not expose remote control to
liquid or other moist environment.
Keep it away from direct sunshine. Remote control will twist under heat.
Federal Communication Commission Interference Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits Class B digital device. Pursuant to part
15 of the FCC rules. This limits are designed to a provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, The user is encouraged to try to correct the interference by one or more the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
-Consult the dealer on an experienced radio/TV technician for help
/
