Colordrift CDMEDIA-100-463 Installation guide

Type
Installation guide

This manual is also suitable for

BLACKOUT LINER PANEL EASY INSTALL GUIDE
47IN X 80IN
Easy to Install with all types of draperies
As a liner for
STANDARD ROD POCKET DRAPES
1. Package contains one 47” wide panel liner that
is intended to hang flat or with gathering behind
your curtain panel.
2. Place the liner on a separate rod.
SEE PICTURE A.
3. Hang the liner, then hang the curtain.
SEE PICTURE B.
4. Purchase additional blackout liners as needed.
(covering windows wider than 47”)
As a liner for
GROMMET OR TAB TOP DRAPES
1. Package contains one 47” wide panel liner
that is intended to be attached flat.
2. Place curtain without rod, face down on a
flat surface. Position blackout liner over the
curtain panel.
3. Insert included pin hooks into the curtain at
evenly spaced points. SEE PICTURE C.
4. Loop the liner braid over the curtin hooks as
shown. SEE PICTURE D.
5. Hang curtain with new liner in place.
As a liner for
PINCH PLEATED DRAPES
1. Package contains one 47” wide panel liner
that is intended to be attached flat or with
some fullness to the back of a 47“ pinch
pleated curtain panel.
2. Place curtain without rod, face down on
a flat surface.
3. Position blackout liner over the curtain panel.
4. Start on the outside and work toward the
center. Loop the liner braid over the curtain
hooks as shown. The liner braid must be facing
the hooks.
5. Carefully work loops toward the bottom of
each hook.
6. Proceed to hang the curtain with the liner in
place.
7. Hook the included extra pin hook into the first
loop of the braid on the right side of the panel.
8. Hook the pin to the carrier on the curtain rod.
PICTURE A
PICTURE C
PICTURE B
©Colordrift LLC, 2018, 110 York St., Brooklyn, NY 11201 RN136432
PICTURE D
  • Page 1 1

Colordrift CDMEDIA-100-463 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI