Noble House 305944 Operating instructions

Type
Operating instructions

This manual is also suitable for

Assembly Instructions
CHAIR
Caution: You must read this before you proceed
CAUTION : This Chair is NOT a TOY.
Keep your child / children at bay during the assembly process.
For turning the Chair and to prevent damage to the Chair, 02 persons may be needed
to execute this action.
Assembly Instructions
Noble House Home Furnishings LLC
1/7
No. Picture Description QTY
A Backrest Panel 1
B Right Leg Panel 1
C Left Leg Panel 1
D Seat Panel 1
E Seat Cushion 1
No. Picture Description QTY
Allen Key 1
Screw (M6*60mm) 7
Parts List
Hardware
Noble House Home Furnishings LLC
1/7
2/7
Assembly Preparation
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Chair parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
Before Beginning Assembly:
Assembly Steps
Overview
Right Leg Panel (B)
Left Leg Panel (C)
Backrest Panel (A)
Seat Cushion (E)
Seat Panel (D)
Noble House Home Furnishings LLC
1/7
3/7
Unpack and place all parts on a clean, non-marring surface.
2.1) Align Backrest Panel (A) and Seat Panel (D) onto Left Leg Panel (C) as shown above.
2.2) Align Right Leg Panel (B) onto Backrest Panel (A) and Seat Panel (D) as pictured.
Noble House Home Furnishings LLC
4/7
Carefully turn the Chair over.
Attach Left Leg Panel (C) to Seat Panel (D) and Backrest Panel (A) by using 3 Screws () with
Allen Key ().
Do not fully tighten the Screws.
Attach Right Leg Panel (B) to Seat Panel (D) and Backrest Panel (A) by using 3 Screws () with
Allen Key ().
Do not fully tighten the Screws.
Noble House Home Furnishings LLC
5/7
Place Seat Cushion (E) onto the Chair.
Lay the Chair down and tie the velcro straps of the Cushion (E) to the Seat Panel (D) as shown
above.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Step 6
Step 5
Place the Chair onto a level surface, then carefully sit onto the Chair.
This pressure will help the Chair reach full alignment at all joints.
In a sequential manner, gradually tighten all Screws until evenly secured.
Inspect the Chair and make sure all parts are adequately connected.
Noble House Home Furnishings LLC
6/7
Noble House Home Furnishings LLC
7/7
Page1 of 6
Caution : You must read this before you proceed
TABLE
CAUTION : This Table is NOT a TOY.
Keep your child / children at bay in the process of
assembly.
For turning the Table and to prevent damage to the Table,
02 persons may be needed to execute this action.
Noble House Home Furnishings LLC
Page2 of 6
Label Picture Description QTY
A Table Top 1
B Leg 4
Label Picture Description QTY
Bolt
(M8x55mm)
9
Spring Washer
(M8.5/10.5x2mm)
9
Flat Washer
(M8.5/16x2mm)
9
Allen Key 1
Noble House Home Furnishings LLC
Page3 of 6
Overview
Before Beginning Assembly:
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Table parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before
assembly.
FRONT FACING
Table top (A)
Leg (B)
Noble House Home Furnishings LLC
Page4 of 6
Step 1
Step 2
Unpack and place all parts on a clean, non-marring surface.
Step 2.1
A
4
2
2.1) With assistance from your adult partners, turn the Table Top (A) up
side down as picture shown
2.2) Attach Leg (B) to Table Top (A) by using Bolt (), Spring Washer
(), Flat Washer () and Allen Key ()
Repeat the same process with the other 3 Legs (B)
Do not fully tighten the Bolts.
Step 2.2
A
A
B
1
3
2
Noble House Home Furnishings LLC
Page5 of 6
Step 3
With assistance from your adult partners, turn the Table back to
normal flat ground
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at
all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Bolts until evenly
secured.
Inspect the Table and make sure all parts are adequately
connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Noble House Home Furnishings LLC
Page6 of 6
OUTDOOR
Noble House Home Furnishings LLC
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13

Noble House 305944 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI