Sharp ANPR1500H Operating instructions

ANPR1500H
Sharp
Brand
Sharp
Model
ANPR1500H
Type
Operating instructions

This manual is also suitable for

1
Accessories
TINSEA216AWZZ
08D R MW 1
2
Installing the main unit and
the subwoofer
3
Remote control battery installation
4
To turn the power on
1 Open the battery cover.
2 Insert the batteries as shown.
3 Close the cover.
Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).
MODEL
AN-PR1500H
HOME CINEMA RACK SYSTEM
This quick Start Guide will help you to correctly install and operate your system.
1
Wire clips x 5
Wooden shelf board x 1
FM aerial x 1
Screw cover x 8
Remote control x 1
"AA" size batteries (UM/SUM-3,
R6, HP-7 or similar) x 2
Top glass cover x 1
Cleaning cloth x 1
HMDI cable x 1
1. Pull up both speakers outwards.
2. Turn the unit. Place the glass shelf on top of it.
3. Place the wooden shelf on top of the screw.
4. Cover the screws on the speakers with the screw covers provided.
Notes:
It is advisable for the top glass cover to be carried by 2 persons.
Top glass with sticker on its surface, must face upwards.
The maximum load for the top glass cover on the unit is 80 kg.
The glass is made of reinforced glass, but dropping pointed objects on it
or strongly hitting the surface may cause it to break.
The top glass cover and wooden shelf board are not fastened to the unit.
Take care when transporting the unit, otherwise these parts may fall off
and there is a risk of damage and injury.
Protection
sheet
Top glass cover cushion
Wooden shelf
Top glass cover
Sticker up side
Screw cover
After checking all the connections have been made correctly, connect the
AC power lead to the wall socket.
Wall socket
(AC 220 - 240 V ~ 50 Hz)
5
Turn on your system
Playing a disc
Playback on USB memory device
XL-UR230/250/2110HE QG 1/17/07, 4:44 PM2
1 2 3
4
5 6
7 8
9
+100
1
Press the DVD/CD button on the remote control or FUNCTION
button repeatedly on the main unit to select DVD/CD function.
3
Some discs play automatically. If playback does not start, press
the (DVD/CD ) button.
2
Insert the disc into the disc slot, label side up.
The disc must be fully inserted into the disc slot before playing.
If “NO DISC” appears due to improper disc insertion, switch off the
AC power supply and then switch it on again.
8 cm disc can be inserted without an adaptor.
8 cm (3")
or
12 cm (5")
Press the ON/STAND-BY button.
If the power does not turn on, check whether the power lead is plugged
in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Note:
After the unit enters the power stand-by mode, wait a few seconds to
turn on again.
1
2 3
4 5 6
7
8 9
+100
1 Remove the USB terminal cover. Connect the USB device. Press the (USB ) button.
2 Press the or button to select data types recorded in USB memory device.
3
Press ENTER button to choose folder types.
4 Select desired track to be played back by pressing , , or . Then press ENTER or (USB ) button.
This function is only visible when connected to TV.
To select USB function, press the FUNCTION button (main unit) or AUX button (remote control) repeatedly.
1 2 3
4 5 6
7 8
9
+100
  • Page 1 1
  • Page 2 2

Sharp ANPR1500H Operating instructions

ANPR1500H
Sharp
Brand
Sharp
Model
ANPR1500H
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents