O.E.M 20RB-D1L Program Chart

Brand: O.E.M

Model: 20RB-D1L

Category: Fridges

Type: Program Chart

This manual is also suitable for

QUICK START GUIDE

6th Sense

(Sixth Sense Function)

This activates automatically to signal that the

appliance is working to reach optimal storage

conditions.

Freezer compartment temperature

Press the button "Freezer temp" to change the

temperature setting.

Freezer compartment door open

Malfunction Alarm

See section "What to do if...".

Reset Filter Alarm

(Acoustic alarm mute

button)

Press the "Reset

Filter/Alarm" button to

stop the acoustic alarm.

Blackout Alarm

See section "What to do if...".

Fast freezing

(Fast Freeze Function)

To be activated several hours before food to be

frozen is placed in the freezer compartment (24

hours before freezing large quantities of food).

To activate this function, press the "Fast freezing"

button: the symbol will appear on the display.

The function disables automatically after 24 hours or

can be switched off manually by pressing the button

again.

Child Lock

(Child Safety)

To lock/unlock the buttons on the control panel, press the "Child Lock"

button. The symbol appears on the display and an acoustic signal

sounds.

Freezer Compartment

N. Inside light

O. Glass shelves / racks (depending on the model)

P. Drawer / top basket (depending on model)

Q. Drawer / bottom basket (depending on model)

R. Door trays

Refrigerator Compartment

A. Internal light (depending on the model)

B. Shelves

C. Shelf - drawer lid

D. Snack drawer (depending on model)

E. Crisper drawer

F. Crisper drawer moisture control (where provided)

G. Meat / crisper drawer

H. Meat / crisper drawer temperature control (where

provided)

I. Rating plate

J. Dairy compartment

K. Door trays

L. 2 litre door tray with

bottle holder (if supplied)

M. 0.75 litre door tray









훽

훾



훿

















Specifications, technical data and images may vary

from model to model.

Connect the appliance to the power supply (see

installation manual).

Read the user handbook carefully before using the

appliance.

Refrigerator compartment door open

Vacation Mode

(Vacation Function)

This function can be used during extended absences.

Press the "Vacation mode" button to enable/disable

the function. The symbol lit up indicates that the

refrigerator compartment is kept at a much less cold

temperature. After activating this function, remove

all perishable foodstuffs from the compartment and

leave the door closed: the refrigerator will maintain

the right temperature to prevent odours from

forming.

The freezer compartment remains enabled: it is

therefore possible to continue to use it as usual.

Refrigerator compartment temperature

Press the "Fridge temp" button to change the

temperature setting.

Anti-bacterial and anti-odour filter

(where provided)

Change the filter when the symbol blinks.

When you have replaced the filter, press the

"Reset filter/alarm" button until the symbol

remains permanently on.

For Europe only

00800-40088400 - www.whirlpool.eu/myfridge

Eco Mode

This function enables you to save energy. To

enable/disable the function, press the "Reset

filter/alarm" and "Child Lock" buttons at the same

time for 5 seconds until the acoustic signal sounds.

When the function is activated, the display only lights

up when you use the appliance or the control panel,

otherwise only the symbol is shown.

Remember that this operation does not disconnect

the appliance from the power supply.

5019 315 01039

What to do if… Possible causes Solutions

Before contacting the After-sales Service, try to solve the problem by following the advice below.

The appliance is excessively

noisy

Noises from appliances are normal since the fans and compressors

for controlling its operation switch on and off automatically, for

example:

• hissing when the appliance is switched on the first time or after a

long period.

• gurgling when the refrigerant enters the pipes.

• humming when the water valve or fan are activated.

• rattling when the compressor starts up or when the ice drips in

the bucket.

• a sudden thud when the compressor starts up or stops.

Some noises can be reduced by:

• levelling the appliance and installing it on a flat surface,

• separating and preventing contact of the appliance with the

cabinets,

• making sure the inside parts are correctly positioned,

• making sure the bottles and containers are not touching each

other.

The control panel is off and/or

the appliance is not working

There may be a problem with the power supply to the appliance

Check that:

• there has not been a power failure.

• the plug is inserted properly into the power socket and the

bipolar mains switch is in the right position (i.e. power supplied to

the appliance).

• the safety protection devices in the domestic electrical system are

working.

• the power cable isn't broken.

• the voltage is correct.

The "Standby" (depending on the model) or "Eco mode" function

may have been enabled.

• Disable the function (see the Quick Start Guide).

If the motor seems to run too

much

On hot days or if the room is warm, the motor naturally runs

longer. Furthermore, if the appliance door has been left open for a

while or if large amounts of food have been stored, the motor will

run longer in order to cool down the interior of the appliance.

Avoid locations in direct sunlight or near a source of heat.

There may be dust or fluff in the condenser.

Remove the front plinth (see installation manual) and clean the

condenser using a vacuum cleaner.

The doors may not be closed properly or the seals may not be

intact.

Check that the doors are closed properly and that the door seals

do not allow any air infiltration.

Excessive moisture inside the

compartments.

If the room is very humid, it is normal for moisture to build up

inside the appliance.

Install the appliance in a dry, well-ventilated place.

The air ducts may be blocked.

Make sure the air ducts inside the compartments are not blocked, as

this prevents the circulation of cold air.

It is not cold enough inside the

compartments

There could be various causes

Check that:

• the doors close properly.

• the appliance is not near a heat source.

• the air ducts inside the compartments are not blocked, as this

prevents the circulation of cold air.

• the "Vacation mode" function is not enabled (see Quick Start Guide)

If necessary, lower the temperature.

The area in contact with the seal

is hot.

This is normal in hot weather and when the compressor is running. No action is required.

If the doors do not open and

close properly.

The door seals may be dirty or sticky. Clean the seals.

The appliance may not be level. If necessary, level the appliance (see Installation manual).

The internal light is not working.

The "Standby" function may have been enabled (depending on the

model).

Disable the function (see the Quick Start Guide).

The bulb may be burnt out.

Replace the bulb (see Instructions for Use, section "Maintenance

and Cleaning").

The control panel will not do

anything: every time a button is

pressed, the acoustic signal

sounds.

The "Child Safety", "Key Lock" or "Ice/water dispenser lock"

function may have been enabled.

Disable the function (see the Quick Start Guide).

The "Compartment door open"

symbols blinks and an acoustic

signal sounds (if present)

Open door alarm.

The alarm is activated when the doors are left open for more than

2 minutes.

Close the doors or press the mute alarm button to switch off the

acoustic signal.

There are letters on the display,

and an acoustic signal is sounding

(if provided and not previously

disabled).

Malfunction Alarm

The alarm indicates that a technical component has malfunctioned.

Call an authorized After-Sales Service. Press the mute alarm button

to switch off the acoustic signal.

The "Eco mode" function may have been enabled. Disable the function (see the Quick Start Guide).

What to do if… Possible causes Solutions

The red Blackout Alarm LED

and the freezer temperature

display are blinking, and the

acoustic signal is sounding (if

provided).

Blackout Alarm. This alarm activates when there has been an

extended power failure causing the freezer compartment

temperature to rise. The value flashing on the freezer display is the

highest temperature reached during the power failure.

Press the mute alarm button to switch off the acoustic signal. Check

the state of foodstuffs before consuming them.

This alarm may be activated when the appliance is used for the first

time.

Press the mute alarm button to switch off the acoustic signal. The

appliance needs approximately 2-3 hours to reach the correct

temperature to store a normal fridge load of food.

The "Anti-bacterial filter" symbol

is red and/or is blinking.

Anti-bacterial filter exhausted (if installed). Replace the filter (see the Quick Start Guide).

The "Water filter" symbol has

changed colour.

Water filter running out/exhausted (where provided).

Replace the filter (see the Quick Start Guide). To replace the filter,

refer to the Instructions for Use.

If the appliance has a water and ice dispenser:

The automatic ice-maker does

not work.

A new appliance takes about a night to reach the ideal temperature

for producing ice.

Wait for the time required for the temperature inside the freezer to

reach the set value.

The automatic ice maker may not be enabled (in some models it

can be disabled).

Refer to the Quick Start Guide to enable the automatic ice maker

again (on some models only).

Water may not reach the automatic ice maker.

Check that the product is connected to the mains water supply and

that the water tap is open.

The water filter may be clogged or installed incorrectly.

Refer to the filter installation instructions to ensure that the filter

was installed correctly and is not clogged. If installation or clogging

is not a problem, call qualified personnel.

The dispenser does not

dispense ice when the lever is

pressed.

This is normal when the freezer door is open, or if the ice bucket is

not installed correctly.

Close the freezer door and/or check that the ice bucket is installed

correctly.

The "Child Safety" or "Ice/water dispenser lock" function may have

been enabled.

Disable the function (see the Quick Start Guide).

Ice cubes may be stuck because the ice dispenser has not been used

for some time: The dispenser may not have been used for extended

periods, causing the ice cubes to stick together.

Change the ice selection from "ice cubes" to "crushed ice" or vice

versa (in some models only), so as to remove any ice blocks. If the

dispenser continues not to dispense ice, wait for two minutes and

then repeat this operation.

Shake the ice bucket to separate the cubes and increase the holding

capacity. It is advisable to throw away the old ice and make new ice.

The ice dispenser lever may have been pressed for too long. Wait about 3 minutes for the dispenser motor to reset

The dispenser does not

dispense water when the lever

is pressed.

During the first delivery, there will be a delay of 15 to 20 seconds

due to the system needing to fill with water.

Wait for the time required for the system to fill.

The "Child Safety" or "Ice/water dispenser lock" function may have

been enabled.

Disable the function (see the Quick Start Guide).

The water filter may be clogged or installed incorrectly.

Refer to the filter installation instructions to ensure that the filter

was installed correctly and is not clogged. If installation or clogging

is not a problem, call qualified personnel.

There is condensation in the ice

and water dispenser area.

The dispenser anti-condensation device may have been disabled

(depending on the model)

Reactivate the function by pressing the anti-condensation switch in

the ice/water dispenser area (marked with an arrow in the figure),

depending on the model.

There is condensation on the

door.

The door anti-condensation function may have been disabled

(depending on the model)

Reactivate the function by pressing the anti-

condensation switch in the ice/water dispenser

area (marked with an arrow in the figure),

depending on the model.

The automatic ice maker

Since the appliance is equipped with an automatic ice-maker, you

may hear a humming sound (coming from the water valve), water

trickling and the sound of ice falling into the bucket.

Disable the automatic ice maker if you do not need it (see the

Quick Start Guide), depending on the model.

QUICK START GUIDE

5019 315 01039

O.E.M 20RB-D1L Program Chart

Brand: O.E.M

Model: 20RB-D1L

Category: Fridges

Type: Program Chart

This manual is also suitable for

Download PDF

report

O.E.M 20RB-D1L Program Chart

This manual is also suitable for

O.E.M 20RB-D1L Program Chart

Related papers

Other documents