JBL PERFORMANCE P35 Owner's manual

Category
Loudspeakers
Type
Owner's manual

This manual is also suitable for

JBL PERFORMANCE P35

The JBL PERFORMANCE P35 is a 3-Way dual 5" center speaker that can be used to complement all of the Performance™ Series loudspeakers, creating a cinematic experience in your home. With a maximum recommended amplifier power of 150W and a power handling of 75W/300W, it delivers a powerful and immersive sound. The speaker has a nominal impedance of 8 Ohms, a sensitivity of 91dB, and a frequency response of 75Hz – 20kHz.

JBL PERFORMANCE P35

The JBL PERFORMANCE P35 is a 3-Way dual 5" center speaker that can be used to complement all of the Performance™ Series loudspeakers, creating a cinematic experience in your home. With a maximum recommended amplifier power of 150W and a power handling of 75W/300W, it delivers a powerful and immersive sound. The speaker has a nominal impedance of 8 Ohms, a sensitivity of 91dB, and a frequency response of 75Hz – 20kHz.

SPEAKER PLACEMENT
Proper placement of the
speakers is an important step
in obtaining the most realistic
soundstage possible. These
recommendations are for the
optimum placement of the
loudspeakers. Use these
placement recommendations
as a guide. Slight variations
will not diminish your listen-
ing pleasure.
The Performance
Series
loudspeakers referred to in
this guide are video-shielded
and can safely be placed
near a television.
MODELS: P25, P35
56 ft.
(1.5–1.8m)
4
0
2 ft.
(0–0.6m)
The P25 and P35 center
channel loudspeakers are
designed to complement all
of the Performance
Series
loudspeakers. It is the ideal
way to re-create the cine-
matic experience in your
home.
P25, P35
PERFORMANCE
SERIES
OWNER’S GUIDE
®
Performance P25-35 OM 10/6/05 3:42 PM Page 3
MODELS: P25,
P35
Speakers and electronics ter-
minals have corresponding (+)
and (–) terminals. It is impor-
tant to connect both speakers
identically: (+) on the speaker
to (+) on the amplifier and (–)
on the speaker to (–) on the
amplifier. Wiring “out of
phase” results in thin sound,
weak bass and poor imaging.
To use the binding-post
speaker terminals, unscrew
the colored collar until the
pass-through hole in the cen-
ter post is visible. Insert the
bare end of the wire through
this hole; then screw the collar
down until the connection
is tight.
The hole in the center of each
collar is intended for use with
banana-type connectors. To
comply with European CE
certification, these holes are
blocked with plastic inserts at
the point of manufacture. To
use banana-type connectors
requires the removal of the
inserts. Do not remove these
inserts if you are using the
product in an area covered by
the European CE certification.
MODELS: P25, P35
The supplied self-adhesive
rubber feet may be attached
to the bottom corners of your
speakers to protect your
furniture.
Receiver
Speaker Outputs
L
+
CENTER
CENTER
+
SPEAKER CONNECTIONS
Performance P25-35 OM 10/6/05 3:42 PM Page 4
TROUBLESHOOTING
If there is no sound from
a
ny of the speakers:
Check that receiver/ampli-
fier is on and that a source is
playing.
Review proper operation of
your receiver/amplifier.
I
f there is no sound com-
ing from one speaker:
Check the “Balance”
control on your receiver/
amplifier.
Check all wires and connec-
tions between receiver/
amplifier and speakers.
Make sure no wires are
touching other wires or
terminals and creating a
short circuit.
Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
In Dolby
®
Digital or DTS
®
modes, make sure that the
receiver/processor is config-
ured so that the speaker in
question is enabled.
• Turn off all electronics and
switch the speaker in ques-
tion with one of the other
speakers that is working cor-
rectly. Turn everything back
on, and determine whether
the problem has followed the
speakers, or has remained in
the same channel. If the
problem is in the same chan-
nel, the source of the prob-
lem is most likely with your
receiver or amplifier, and
you
should consult the owner’s
manual for that product for
further information.
If the
problem has followed the
speaker, consult your dealer
for further assistance or, if
that is not possible, visit
www.jbl.com for further
information.
If the system plays at
l
ow volumes but shuts
o
ff as volume is
increased:
Check all wires and connec-
tions between receiver/
amplifier and speakers.
Make sure all wires are
connected. Make sure none
of the speaker wires are
frayed, cut or punctured.
If more than one pair of
main speakers is being used,
check the minimum imped-
ance requirements of your
receiver/amplifier.
If there is no (or low)
bass output:
Make sure the polarities
(+ and –) of the left and right
“Speaker Inputs” are
connected properly.
Consider adding a powered
subwoofer to your system for
use with digital “.1” surround
formats.
We, Harman Consumer Group International
2, route de Tours
72500 Chateau du Loir
France
declare in own responsibility that the loud-
speaker described in this owner’s manual is
in compliance with technical standards:
EN 61000-6-3:2001
EN 61000-6-1:2001
Laurent Rault
Harman Consumer Group International
Chateau du Loir, France 10/05
Declaration of Conformity
Performance P25-35 OM 10/6/05 3:42 PM Page 5
P25 P35
D
escription Description
2-Way, dual 5" center 3-Way dual 5" center
M
ax. Recommended Amplifier Power* Max. Recommended Amplifier Power*
1
50W 150W
Power Handling (Continuous/Peak) Power Handling (Continuous/Peak)
7
5W/300W 75W/300W
Nominal Impedance Nominal Impedance
8 Ohms 8 Ohms
S
ensitivity (2.83V/1m) Sensitivity (2.83V/1m)
90dB 91dB
Frequency Response (–3dB) Frequency Response (–3dB)
8
0Hz – 20kHz 75Hz – 20kHz
Crossover Frequency Crossover Frequency
4000Hz 800Hz, 3200Hz
High-Frequency Transducer High-Frequency Transducer
3/4" (19mm) Titanium-laminate dome, shielded 3/4" (19mm) Titanium-laminate dome, shielded
Low-Frequency Transducer Midrange Transducer
Dual 5" (130mm) PolyPlas,
shielded 3" (75mm) PolyPlas,
shielded
Baffle Low-Frequency Transducer
Low diffraction, IsoPower
Dual 5" (130mm) PolyPlas,
shielded
Port Baffle
FreeFlow
flared Low diffraction, IsoPower
Network Port
Straight-Line Signal Path
(SSP) FreeFlow
flared
Terminals Network
Gold-plated, 5-way binding posts Straight-Line Signal Path
(SSP)
Dimensions (H x W x D) Terminals
6-7/8" x 18" x 10" (175mm x 457mm x 254mm) Gold-plated, 5-way binding posts, bi-wirable
Weight per Speaker Dimensions (H x W x D)
15.6 lb/7.1kg 7-1/4" x 22" x 10-7/16" (185mm x 558mm x 264mm)
Weight per Speaker
22 lb/10kg
SPECIFICATIONS
2
DESIGN GOAL: Bring the thrill of live performance and movie sound to the
home environment by calling on JBLs professional engineering leadership.
TWEETER TYPE: Pure-titanium dome with EOS™ waveguide
WOOFER TYPE: Cast-aluminum basket with HeatScape™ motor structure
CROSSOVER NETWORK: Straight-Line Signal Path™ (SSP)
ENCLOSURE DESIGN: Sealed
PROFESSIONAL REFERENCE: Studio Monitor
OWNER’S GUIDE
PRODUCT
LINE:
MODEL:
P25, P35
PERFORMANCE
SERIES
© 2005 Harman International Industries, Incorporated.
All rights reserved.
Part No.
361821-001
PRO SOUND
COMES HOME
JBL Consumer Products
250 Crossways Park Drive, Woodbury, NY 11797
8
5
00 Balboa Boulevard,
Northridge, CA 91329
2, route de T
ours, 72500 Chateau du Loir
, France
516.255.4JBL (4525) (USA only)
www
.jbl.com
JBL and Harman International are registered trademarks, and Performance Series, Pro Sound Comes Home, PolyPlas,
IsoPower, FreeFlow and Straight-Line Signal Path are trademarks, of Harman International Industries, Incorporated.
Dolby is a registered trademark of Dolby Laboratories.
DTS is a registered trademark of DTS, Inc.
* The maximum recommended amplifier power rating will ensure proper system headroom to allow for occa
sional peaks. We do not recommend sustained operation at these maximum power levels.
All features and specifications are subject to change without notice.
Performance P25-35 OM 10/6/05 3:42 PM Page 2
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

JBL PERFORMANCE P35 Owner's manual

Category
Loudspeakers
Type
Owner's manual
This manual is also suitable for

JBL PERFORMANCE P35

The JBL PERFORMANCE P35 is a 3-Way dual 5" center speaker that can be used to complement all of the Performance™ Series loudspeakers, creating a cinematic experience in your home. With a maximum recommended amplifier power of 150W and a power handling of 75W/300W, it delivers a powerful and immersive sound. The speaker has a nominal impedance of 8 Ohms, a sensitivity of 91dB, and a frequency response of 75Hz – 20kHz.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI