![](//vs1.manuzoid.com/store/data-gzf/8d9174f3346e4cf46e80d26c0f27670e/2/001896418.htmlex.zip/bg2.jpg)
TO BEGIN USING YOUR
AIRPURA
Inspect the exterior of your Airpura to verify there is no damage from shipping.
If any damage is noted, please follow the instructions in the Airpura returns policy.
Assemble the unit by attaching the top cover and the outlet elbow following the
assembly instructions.
Install the unit following the installation instructions
Plug the unit into a regular grounded 110 volt outlet
Turn on the unit to MAX and allow it to run for a few minutes
Set the variable speed control to the level you wish
The most ecient way to use your Airpura for regular air quality maintenance
is to run it at a low speed 24 hours a day 7 days a week.
FILTER MAINTENANCE AND REPLACEMENT
The Activated Carbon Filter
Should be changed as needed in heavy applications and at least every 24
months in normal use.
The HEPA Filter
Should be replaced at least every 3 to 5 years of normal use
The Pre-Filter
Should be replaced at least every 6 to 12 months of normal use
IMPORTANT SAFETY NOTE
Please ensure air purier is turned OFF when plugging into a power source.
Failure to do so may result in motor potentially stalling and/or burning.
REPLACING THE UV BULB
Open the lter chamber following the instructions
Pull the bulb upward out of the connector
Push the replacement bulb rmly into the connector
Close the lter chamber following instructions
MinMax
Off
1
MinMax
Off
2
MinMax
Off
3
FILTER REPLACEMENT
Always unplug the unit before lter replacement.
Remove the 4
screws on top
Put in the new
prelter
Pull out the
carbon lter
Take off
the top
Replace the
top felt gasket
Pull out the
hepa lter
Take off
the felt gasket
Place de top cover
so the 4 holes align
Replace the bottom
felt gasket
Pull out the
prelter
Tighten the 4
screws
Put in the new
carbon lter