Astria Fireplaces Capella Series Instruction Sheet

Brand: Astria Fireplaces

Model: Capella Series

Type: Instruction Sheet

This manual is also suitable for

ERT3000-old

www.IHP.US.com 126750-01A

P/N 775178M Rev. B 05/2015

P775178M HEARTH PRODUCTS

KITS AND ACCESSORIES

POWER CORD KIT

Model: PCK Catalog No. H1645

INSTALLATION INSTRUCTIONS FOR 110V POWER CORD KIT

FOR USE WITH MODELS MPE33-2 AND MPE36-2 ELECTRIC FIREPLACE

INSTALLATION INSTRUCTIONS FOR 110V POWER CORD KIT

FOR USE WITH MODELS MPE-33R AND MPE-36R ELECTRIC FIREPLACE

 LENNOX HEARTH PRODUCTS 2004

P/N 775,178M REV.A 12/2005 Page 1 of 1 1110 West Taft Avenue • Orange, CA 92865

LENNOX HEARTH PRODUCTS

KITS AND ACCESSORIES

Cat. No. Model Description

H1645 PCK Power Cord Kit

775,178M REV.

12/2005

LENNOX reserves the right to make changes at any time, without notice, in design, materials,

specifications, prices, discontinued colors, styles and products. Consult your local distribu-

tor for fireplace code information.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

‘

KIT CONTENTS:

1 ea. Power Cord

1 ea. Cover Plate w/Cord Restraint

1 ea. Instruction Sheet

TOOLS REQURED:

Wire Stripper

Blunt Nose ("Linesman") Pliers

INSTALLATION INSTRUCTIONS:

Read all instructions completely before beginning installation.

Step 1. Strip the three wire ends on power cord, approximately

1/2” from the end.

Step 2. Connect wires as shown in Figure 2. Twist wires together

using a pair of blunt nose ("linesman") pliers, tightly, then twist

each wire nut on by hand. After twisting the connector on, give

each wire a tug, to ensure it is secure. DO NOT wrap the "open"

end of the connector with electrical tape to cover. If bare wire

is exposed outside the connector. Instead of taping it, the con-

nection should be redone.

Step 3. Ensure that all control switches are in the off position.

Step 4. Read WARNINGS then plug power cord into wall outlet.

WARNINGS:

• The power cord must not be pinched or against a sharp

edge. Secure cord to avoid tripping or snagging to reduce

the risk of fire, electric shock or personal injury.

• Do not run cord under carpeting. Do not cover cord with

throw rugs, runners or the like. Arrange cord away from

traffic areas and where it will not be tripped over.

• Power cord must plug into a dedicate circuit that is properly

grounded (3-prong), fused (15 Amp.) and polarized 110/120

Volt, 60 Hz outlet only. Note: A dedicated circuit is required

to prevent overloading a house circuit in cases of having

multiple appliances on the same circuit. Use an outlet

that is protected by a ground fault circuit interrupter where

required by electrical code.

• Avoid the use of an extension cord which may overheat

and cause a risk of fire. However, if an extension cord is

used, the cord shall be number 14 AWG minimum size

and rated not less than 1800 Watts, 15 Amps. The exten-

sion cord must be a three-wire cord with grounding type

plug and cord connection.

Cover

Plate

Figure 1

83”

Use Wire Nuts

Provided with

Appliance

POWER CORD KIT

Power

Cord

d Restraint

L1 = Black (Power)

N = White (Common)

G = Green (Ground)

Left Side of

Fireplace

Figure 2

Power Cord

Cover Plate

Astria Fireplaces Capella Series Instruction Sheet

Brand: Astria Fireplaces

Model: Capella Series

Type: Instruction Sheet

This manual is also suitable for

ERT3000-old

Download PDF

report

Astria Fireplaces Capella Series Instruction Sheet

This manual is also suitable for

Astria Fireplaces Capella Series Instruction Sheet

Related papers

Other documents