IMPORTANT SAFETY INSTRUCTIONS
Please read all instructions before using this product.
Save these instructions for easy reference. When using
electrical appliances, basic precautions should always be
followed to reduce breakage, risk of fire, electric shock
and injury to persons including the following:
l Do not use the fan outdoors.
l Never use the fan unless it is fully assembled.
l Do not use the fan under the following conditions: 1)
High temperature of over 104F. 2) High humidity. 3)
Steam filled room.
l Do not push finger or any object through the grilles
and do not touch the fan blade during use; especially
be aware children and infants around during use.
l Take care that curtains or other objects are not
into the fan during operation.
l Do not spray the fan with insecticide, which will
damage the surface of the fan.
l The fan has a polarized plug (one blade is wider than
the other). To reduce risk of shock, this plug is
intended to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug.
not attempt to defeat this safety feature.
l Unplug from wall outlet before servicing.
OPERATION
The control buttons are marked as follows:
0 = OFF
1 = Low fan speed
2 = Medium fan speed
3 = High fan speed
SETUP
Your Stand Fan was thoroughly inspected and tested at
the factory prior to packaging. Visually inspect it upon
removal from its packaging. Return the unit if it shows any
signs of damage or mishandling.
WARNING: To avoid fire or shock hazard, the Stand Box
Fan should ONLY be plugged into a polarized 120 Volt
Step 4: Install the Rear Grille.
Step 5: Screw the Rear Grille Fixer to fasten the Rear
Grille
Step 6: Install the Fan Blade onto the motor shaft.
Step 7: Screw the Blade Fixer to secure the Fan Blade
on the motor shaft.
Step 8: Attach the Front Grille to the Rear Grille.
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com