Mold Armor FG590 is a powerful cleaning solution designed to kill mold, mildew, and bacteria on hard, non-porous surfaces.
Capabilities:
- Kills 99.9% of bacteria, viruses, and fungi
- Prevents mold and mildew growth
- Removes mold and mildew stains
- Treats water damage caused by sewage backup, river flooding, leaky pipes, windows, and roofs
- Safe for use on a variety of surfaces, including acrylic, sealed fiberglass, laminate, steel, glazed porcelain, glass, sealed grout, stainless steel, chrome, glazed ceramic, mirrors, Formica®, Corian®, sealed granite, plastic laminate, linoleum, crystal, and vinyl.
Mold Armor FG590 is a powerful cleaning solution designed to kill mold, mildew, and bacteria on hard, non-porous surfaces.
Capabilities:
- Kills 99.9% of bacteria, viruses, and fungi
- Prevents mold and mildew growth
- Removes mold and mildew stains
- Treats water damage caused by sewage backup, river flooding, leaky pipes, windows, and roofs
- Safe for use on a variety of surfaces, including acrylic, sealed fiberglass, laminate, steel, glazed porcelain, glass, sealed grout, stainless steel, chrome, glazed ceramic, mirrors, Formica®, Corian®, sealed granite, plastic laminate, linoleum, crystal, and vinyl.
PRECAUTIONARY STATEMENTS: Hazards to Humans and Domestic Animals
WARNING: Causes moderate eye irritation. Do not get on skin or on clothing.
Avoid contact with eyes. Wear waterproof gloves and appropriate clothing.
Wash thoroughly with soap and water after handling and before eating,
drinking, chewing gum, using tobacco or using the toilet. Remove and wash
contaminated clothing before reuse.
FG590 / J9185
EPA Registration No. 4091-23
EPA Establishment No. 55852-IL-001
J9184
Kills Mold.
Visible Results
in 1 Minute.
FIRST AID:
IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes.
Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye.
IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately
with plenty of water for 15-20 minutes.
Call a poison control center or doctor for treatment advice. Have the product container
or label with you when calling a poison control center or doctor, or going for treatment.
National Poison Control Center: 1-800-222-1222.
Non-Abrasive Formula
Works Indoors & Outdoors • Contains No Phosphates
Safe for use on: Acrylic, Sealed Fiberglass, Laminate,
Steel, Glazed Porcelain, Glass, Sealed Grout, Stainless Steel,
Chrome, Glazed Ceramic, Mirrors, Formica®, Corian®, Sealed
Granite, Plastic Laminate, Linoleum, Crystal, and Vinyl.
QUESTIONS? COMMENTS?
CALL 888-326-7743
©2019 W.M. Barr & Co., Inc.
Distributed by: W.M. Barr & Co., Inc.
6750 Lenox Center Court
Suite 200, Memphis, TN 38115
No Scrubbing
Required
For Use On Hard
Non-porous Surfaces
NET CONTENTS:
32 FL OZ (946 mL)
KEEP OUT OF REACH OF CHILDREN
WARNING
SEE BACK PANEL FOR ADDITIONAL
PRECAUTIONARY STATEMENTS.
ACTIVE INGREDIENTS:
Sodium hypochlorite......... 4.0%
Sodium carbonate ............ 1.0%
OTHER INGREDIENTS: ... 95.0%
TOTAL: ........................ 100.0%
Kills 99.9% of Pseudomonas
aeruginosa, Salmonella enterica,
Staphylococcus aureus, Trichophyton
mentagrophytes, Aspergillus niger (60 seconds),
Influenza A
H1N1†
, Respiratory Syncytial Virus†, Human
Coronavirus†.
TO PREVENT MOLD AND MILDEW
GROWTH ON HARD
SURFACES: To inhibit mold and mildew growth: Thoroughly
wet surface. Allow to air dry. Repeat every 7 days to inhibit mold
and mildew growth. Effective against Aspergillus niger*. Pre-clean
heavily soiled surfaces.
TO CLEAN AND REMOVE MOLD AND MILDEW STAINS:
Apply to stains. No scrubbing required. Wait 10 minutes for stains to
disappear, then rinse with water or wipe with a damp sponge. Rinse
vinyl or rubber surfaces within 15 minutes as prolonged contact may
cause damage.
TO TREAT WATER DAMAGE CAUSED BY SEWER BACKUP, RIVER
FLOODING, LEAKY PIPES, WINDOWS, ROOFS (NOT FOR USE IN
CALIFORNIA): Extract excess water and remove gross filth or heavy
soil a
long with non-salvageable materials. Test hidden area for
colorfastness.
Saturate affected material with undiluted product using a
sprayer with a coarse spray tip. Allow the materials to remain damp for
at least 1 minute prior to extraction.
STORAGE AND DISPOSAL
Store in original container in areas inaccessible to children. Keep
securely closed. Nonrefillable container. Do not reuse or refill this
container. Place container in trash or offer for recycling.
PHYSICAL AND CHEMICAL
HAZARDS: This product contains an
oxidizing agent. Do not use or mix with
other chemicals such as toilet bowl cleaners,
rust removers, or any cleaners containing acids
or ammonia as hazardous gases may be released.
Prolonged contact with metal may cause pitting or discoloration.
ENVIRONMENTAL HAZARDS: This product is toxic to fish and
aquatic organisms.
DIRECTIONS FOR USE: It is a violation of Federal Law to use this
product in a manner inconsistent with its labeling.
For surfaces that may contact food, a potable water rinse is required.
Do not use on eating/cooking utensils, glasses/dishes or cookware.
Contact with clothing, carpet, fabric, painted wood surfaces or paper
may cause discoloration or damage. Test on a small inconspicuous area
before applying to surface. Safe for use on hard non-porous surfaces.
USE ONLY IN WELL VENTILATED AREAS. Vapors may irritate. Before
use, open windows and turn on fan. If the vapors bother you, leave
the room while the product is working.
TO OPERATE: Rotate nozzle to ON.
TO SANITIZE:
For use on hard, non-porous non-food contact surfaces.
Pre-clean heavily soiled surfaces. Hold container 6˝- 8˝ from surface and
spray until thoroughly wet. Let stand 10 seconds. Wipe clean with a damp
cloth. Kills 99.9% of Enterobacter aerogenes and Staphylococcus aureus.
TO DISINFECT
bacteria, viruses†, and fungi on hard, non-porous
surfaces: Pre-clean heavily soiled surfaces. Hold container 6˝- 8˝ from
surface and spray until thoroughly wet. Let stand 30 seconds. To kill
mold and mildew, let stand 60 seconds. Then rinse with water or wipe
with a damp cloth.
PEEL
HERE
Proven one-step disinfectant, cleaner, sanitizer,
fungicide, mildewstat*
, and virucide†
Kills,
Cleans,
& PREVENTS
mold & mildew
MOLD ARMOR
RAPID CLEAN REMEDIATION
FRONT BACK
OUTSIDE PAGE
INSIDE PAGE
-
1
Mold Armor FG590 is a powerful cleaning solution designed to kill mold, mildew, and bacteria on hard, non-porous surfaces.
Capabilities:
- Kills 99.9% of bacteria, viruses, and fungi
- Prevents mold and mildew growth
- Removes mold and mildew stains
- Treats water damage caused by sewage backup, river flooding, leaky pipes, windows, and roofs
- Safe for use on a variety of surfaces, including acrylic, sealed fiberglass, laminate, steel, glazed porcelain, glass, sealed grout, stainless steel, chrome, glazed ceramic, mirrors, Formica®, Corian®, sealed granite, plastic laminate, linoleum, crystal, and vinyl.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI