MODEL
7113A
Compatible with the
following systems.
Automate 4214A
Automate 4114A
Replacement Transmitter
.
©2018 Directed. Vista, CA 92081. All rights reserved.
MADE IN TAIWAN
P/N 7113A 12/18
REPLACEMENT TRANSMITTER
Model 7113A 1-way 1-button Supercode Remote Control
The following Learn Routine can be used to program this replacement transmitter to the system. To enter the
Learn Routine, the programming button on the Control Center is used.
Remote Functions
System State
Press/Release
Press/Hold
for 3 sec.
ENGINE OFF START ENGINE CAR FINDER
ENGINE ON UNLOCK DOORS STOP ENGINE
FCC/ID Notice
This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION! Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
1. Turn the key to the ON position.
2. Press/release once and then press/hold the
control button on the system's Control Center.
The status LED begins flashing in a sequence of
1 flash and the horn (if connceted) sounds once to
confirm the system is ready for pairing.
3. Release the control button.
4. Press /hold the remote button for 15 seonds. The
LED patterns change while holding. The horn (if
connnected) emits 1 sound to confirm learning.
5. Repeat for each remote to be learned (up to four).
6. Turn the ignition off or wait 60 seconds to exit
learning, the horn emits 2 sounds to confirm.
WARNING:
This product can expose you to chemicals including DEHP, which is known to the State of Califotrnia to cause cancer
and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
560-10082 (R1.0)
/
