3 Operating
GB
15
3.1
Charging
the battery
pack
The battery pack
6
needs to be charged for at least 3 hours prior to initial
use or after not having been used for a long time. To charge the batteries,
connect the cable of the charging unit
1
with the battery pack and a mains
outlet. During the charging process the charging status LED
8
ashes
green. When the batteries have been fully charged, the charging status
LED
8
lights up in green constantly. You now may disconnect the charging
unit
1
from the mains and from the battery pack
6
.
If you want to check the state of charge of the battery pack, disconnect
the power plug of the heat belt
5
from the battery pack and press the on-/
off-button
7
. The charging status LED
8
lights up in green constantly
for approx. 3 seconds, if the state of charge is 25 % or better. If the state
of charge is below 25 %, the charging status LED
8
ashes 3 times in a
second. You then should recharge the battery pack
6
.
IMPORTANT HINTS
• Only charge the battery pack in a dry environment at room
temperature. Never place any objects onto the battery pack.
• BATTERY SAFETY INSTRUCTIONS:
- Do not disassemble or dismantle the battery / battery pack!
Danger of explosion!
- Keep away from î‚¿re and heat sources! Danger of explosion!
- Do not dispose used batteries in the household refuse;
put them in a hazardous waste container or take them to
a battery collection point, at the shop where they were
purchased!
3.2
Usage
1. Insert the battery pack
6
into the integrated battery pack pocket
4
.
Make sure the connection socket for the power plug of the heat belt
5
on the battery pack is placed upwards and the LEDs can be seen
through the window on the pocket on the frontside of the belt.
2. Connect the power plug of the heat belt
5
and the battery pack
6
.
3. Adjust the desired temperature level (1 to 4) by pressing the on-/off-
button
7
(multiply). Each press increases the temperature level by
one step. If level 4 is already adjusted and you press the on-/off-button
7
again, the device will be switched off.
4. Place the heating belt around your back and abdomen and secure the
belt by fastening the Velcro. Depending on the position you put the belt
on, it warms different areas of your body.
5. If desired, you may also use the elastic support band
3
by putting
it around the outer side of the heat belt. This ensures an additionally
supporting effect of the belt.