PELONIS
OWNER’S MANUAL
Fan Forced
Disc Furnace V
Ceramic Heater
Model HC-461
PLEASE READ AND SAVE THESE INSTRUCTIONS
IMPO
RTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers, clo
thes, and curtains at least
3 feet (0.9m) from the front of the heater and keep them away from the sides and
rear.
3. Extreme caution is necessary when any heater is used by or near children or
invalids and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanic
al adjustment, or
repair.
6. Do not use outdoors.
7.
This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into bathtub or other water
container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Arrange cord away from traffic area and where it will not be
tripped over.
9. To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign object
s to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
13.
Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
14.
Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall
be No. 14 AWG minimum size and rated not less than 1875 watts.
15.
This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a l
oose fit between the
AC outlet (receptacle) and plug may cause overheating and distortion of the plug.
Contact a qualified electrician to replace loose or worn outlet.
17. The output of this heater may vary and its temperature may become intense
enough to bur
n exposed skin. Use of this heater is not recommended for persons
with reduced sensitivity to heat or an inability to react to avoid burns.
18.
“SAVE THESE INSTRUCTIONS”
U
L
®
OPERATING INSTRUCTIONS
•
Place the heater on a firm level surface free from obstructions, and at least 3 ft.
away from any wall and any other objects such as furniture, cu
rtains, plants or
combustible material.
• With the Power Button “A” in the ”OFF” position, plug the heater into a
grounded 120V outlet.
• Turn the heater ”ON” by pressing the Power Button “A”. The
Power Indicator
Light “D” will illuminate.
• Set the desired temperature by pressing the Thermostat Control button “UP”
to
increase the temperature or “DOWN” to decrease the temperature. The
desired temperature will be set after the LED display stops flashing.
NOTE: When the desired temperature is set after the LED display stops
flashing, the Room Temperature Display “C” will change to display the room
temperature.
CAUTION: This heater includes a Thermal Cut-Off Overheat Protection System that
shuts the heater off if it overheats due to abnormal conditions. If this occurs, turn the
heater ”OFF”, unplug it, and inspect and remove any objects on or adjacent to the
heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.
PATENTED ELECTRONIC TEMPERATURE CONTROL
Your Disc Furnace is built to last and deliver outstanding performance for years. Unlike
other portable heaters, it uses a patented electronic temperature control that
automatically monitors the e
xact room temperature and compensates for heat loss. As
a result, maximum comfort and energy efficiency are realized.
ROOM TEMPERATURE DISPLAY
The Room Temperature Display C” displays the actual room temperature when the
heater is plugged in or during op
eration. When the heater is operating and the room
temperature near the heater reaches the desired set temperature, the
Temperature Set
Light “E” will illuminate. Note: To turn off the room temperature display, you must
unplug the heater.
Viewing the Set Temperature:
To view the set temperature at any time during the heater’s operation, press the
Thermostat Control “B” button “UP” or “DOWN”. The Room Temperature Display “C”
will flash the desired temperature that has been set. When the display stops f
lashing, it
will change to show the actual room temperature.
PLACEMENT OF THE UNIT IN ROOM
For most efficient heating, place the heater on the floor where the air is cooler, and
about 3 feet from any wall. To heat your room, the heater will be most efficient when
placed near an outside door, the bottom of a staircase, or where colder air is most
likely to be entering the room.
CLEANING THE DUST FILTER
The filter collects dirt and dust from air circulating through the heater. To clean the
filter, rinse it with warm water and allow it to dry before reinstalling.
B
A
Carry Handle
(behind unit)
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug (a plug having one blade
wider than the other). This plug will fit into the power outlet only one way. This is a safety
feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician to replace your outlet. DO NOT defeat the
safety purpose of the polarized plug.
Control Panel View
Control Panel Functions
Power Button Room Temperature Display Temperature Set Light
Thermostat Control Power Indicator Light
A
B
C
D
E
D
E
C
SERVICE & SUPPORT
For usage tips about this heater, to register your heater warranty online, or to obtain
information about other Pelonis USA products, please visit our website at
www.pelonis.com
In the event of a warranty claim or if service is required for this heater, please contact
us at the following:
Toll Free: 1-800-842-1289 or 1-610-695-8700 (M-F 9:00am to 5:00pm EST)
Email us at: [email protected]
For questions or comments, please write to:
Pelonis USA, Ltd.
Att: Consumer Relations Department
P.O. Box 785
Malvern, PA 19355 USA
For your records, staple your sales receipt to this manual and record the following:
DATE OF PURCHASE: ________________________________
___________________________
PLACE OF PURCHASE:________________________________
___________________________
SERIAL NUMBER: ________________________________
______________________________
(STAPLE SALES RECEIPT HERE)
NOTE: PROOF OF PURCHASE IS REQUIRED FOR
ALL WARRANTY CLAIMS
ADDITIONAL FEATURES
This heater has additional features:
• Ambient Temperature Sensor (located on the power cord behind the heater)
–
senses the surrounding room tempe
rature and automatically adjusts the heat
output.
• Safety Tip Over Switch – shuts the heater off if it tips over.
• Convenient Carry Handle – allows for easy transport from room to room.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
• Ensure that your circuit breaker or fuse is working properly.
• Be sure the heater is plugged in and that the electrical outlet is working
properly.
• Check for any obstruction. If you find any obstruction, turn the heater “OFF”
.
Unplug the heater and wait a few minutes for it to cool down. Carefully
remove the obstruction. Plug the heater in and turn it on again by referring to
the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE
WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO
OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY
AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL
PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE & SUPPORT
INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating
season in order to provide the optimum level of performance. ALWAYS TURN THE
POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save
the box for off-season storage.
• Turn the heater “OFF”, unplug it and wait for the heater to cool down.
• Use a dry cloth to clean only external surfaces of the heater.
• Do not use any cleaning agents or detergents.
• Never immerse the heater in water.
• Pack the heater in the original carton and store it in a cool and dry place
SPECIFICATIONS
Model No.: HC-461
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Output: 5200 BTUs
Power: Variable from 0W to 1500W.
Tolerances on all specifications: Approximately +5%, -10%.
SEVEN (7) YEAR LIMITED WARRANTY
• Please read all instructions before attempting to use this product.
• Please return the Warranty Registration card within fifteen (15)
days from the date of purchasing this product.
Pelonis USA, Ltd., referred to hereafter as Pelonis USA, warrants as
limited herein to the original purchaser of retail that each new Pelonis
Disc Furnace ceramic heater, shall be free of defects in material and
workmanship for a period of seven (7) year from the date of original
purchase. This seven (7) year warranty is limited to the heating elements,
motor, and electric control circuit board.
In the event of malfunctions or failure of your Pelonis Disc Furnace
ceramic heater, simply deliver or send the heater, postage prepaid along
with PROOF OF PURCHASE, within the warranty period of seven (7) year,
to Pelonis USA. Pelonis USA reserves the right to inspect the claimed
def
ective part or parts to determine if the defect or malfunction complaint
is covered by this warranty. Pelonis USA shall, within sixty (60) days after
receipt of the product, at its option, repair and/or replace the defective
part or parts free of charge. This warranty shall only cover defects
arising from normal usage. Pelonis USA assumes no responsibility
whatsoever if the Disc Furnace ceramic heater should fail during the
warranty period by reason of:
• Misuse, negligence, physical damage or accidents.
• Lack of maintenance (see instructions for proper maintenance).
• Repair by any unauthorized party during the warranty period.
• Damage caused by connection to an improper input voltage (see
specification label on your heater).
Pelonis USA makes no further warranties or representations, express or
implied except those contained herein. No representative or dealer is
authorized to assume any other liability regarding the Disc Furnace
ceramic heater. The duration of the implied warranty granted under
State law, including warranties of merchantability and fitness for
particular purpose are limited in duration should the duration of the
express warranty grant it hereunder. Pelonis USA shall in no event be
liable for direct, indirect, special or consequential damages.
Some states do not allow limitations on how long an implied warranty
lasts, and/or the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights and you may have other
rights which vary from state to state.
Shou
ld your Disc Furnace ceramic heater fail to operate under the terms
of this limited warranty, contact Pelonis USA at 1-800-842-1289 or 1-610-
695-8700 (M-F 9:00am to 5:00pm EST).
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- español: Pelonis HC-461 Manual de usuario
Related papers
-
World Marketing of America Disc Furnace III HC-451 Owner's manual
-
Pelonis HC-445B Owner's manual
-
Pelonis PSH700 Owner's manual
-
Pelonis HC-451 Disc Furnace III User manual
-
Pelonis HC-350 User manual
-
-
-
Pelonis HR-0031 User manual
-
-
Other documents
-
-
-
SAI DF1511-A User guide
-
OmniHeat DQ1709 Operating instructions
-
Nomura NPO-15D-2 Installation guide
-
Airlogic AW300 User manual
-
OmniHeat DQ1711 Operating instructions
-
Cozy Products ESH Operating instructions
-
none H1017 User guide
-
Honeywell HZ-850 User manual
