4
5. Lower the jug onto the motor unit and twist it clockwise to lock it. Your blender will not operate
unless the jug is correctly fitted and locked.
USING
Your blender will automatically switch off after 2 minutes of continuous use.
It is normal for the off (0) button to flash when in standby. However, if the off button flashes very rapidly,
and the unit doesn’t work when any of the buttons are pressed, unplug it from the supply socket then
reconnect it and try again.
1. Remove the lid.
2. Put the ingredients into the jug.
3. Don’t fill past the 1700ml mark. If you do, the contents may force the lid off when you start the motor.
4. Replace the lid. Never operate the appliance without fitting the lid.
5. Fit the cap to the hole in the lid, and turn it anti-clockwise to lock it.
6. Don’t run the appliance without fitting the cap.
7. Press the 1 or 2 button to start your blender.
8. Press the 0 button to stop your blender
9. Alternatively, press the pulse Y button in short bursts until the desired consistency is obtained.
10. To add ingredients while the blender is working, remove the cap, pour the new ingredients through
the hole, then replace the cap.
When you have finished:
• Switch the appliance off (0) and unplug it.
CRUSHED ICE
Before using the appliance to crush ice, make sure it’s clean, and rinse it out thoroughly.
The slightest trace of detergent may affect the taste of the crushed ice, and will flatten any drink to which
it is added.
For best results, full the jug with between 150ml and 500ml of ice cubes.
Put the lid on the blender, then:
1. Press the pulse button Y for a second or two, then release it.
2. Check the results, and adjust.
STORING
1. To reduce the amount of space required to store your blender, place the jug over the motor unit and
the lid over the base of the jug as shown.
2. The power cord can be stored coiled up under the base of the motor unit.
CARE AND MAINTENANCE
• Switch the appliance off (0) and unplug it.
3. Wipe the outside of the motor unit with a clean damp cloth.
4. Hand wash the removable parts.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes.
The damage should be cosmetic only, and should not affect the operation of the appliance.
BLADE UNIT
You may wish to remove the blade unit for cleaning.
1. Remove the lid.
2. Sit the jug upside down.
3. Unscrew the jug base and lift it off.
4. Carefully, lift the blade unit out of the jug. Handle only the plastic – don’t touch the metal parts.
