HOUZER VISPD-869-PC Installation guide

HOUZER
Brand
HOUZER
Model
VISPD-869-PC
Category
Faucets
Type
Installation guide

This manual is also suitable for

HOUZER VISPD-869-PC is a vision pull down faucet with a recommended pressure range of 15-88 PSI (1-6 bar) and a maximum temperature of 176 F (80 c). It features a mixer that is operated by moving the handle, allowing for precise control of water temperature and flow. The pull-out spray hose provides extended reach and versatility, with a flow that can be changed from aerator to spray mode by pushing down on the diverter button located on top of the handspray. After the water flow has been shut off, the handspray automatically reverts back to aerator mode.

HOUZER VISPD-869-PC is a vision pull down faucet with a recommended pressure range of 15-88 PSI (1-6 bar) and a maximum temperature of 176 F (80 c). It features a mixer that is operated by moving the handle, allowing for precise control of water temperature and flow. The pull-out spray hose provides extended reach and versatility, with a flow that can be changed from aerator to spray mode by pushing down on the diverter button located on top of the handspray. After the water flow has been shut off, the handspray automatically reverts back to aerator mode.

VISPD-869 Vision Pull Down Faucet
304869
Instructions:
1. Flush out some water from hot and cold valve in
the wall. This will ensure smooth operation during
the faucet life.
2. Insert faucet body through deck plate and into sink
or counter.
3. Remount rubber washer followed by plastic bace,
if necessary, and metal washer to faucet shank under
sink. Remount lock nut to shank and hand-tighten.
4. Be sure the faucet is aligned properly. Make final
tightening of lock nut.
5. Connect pull-out spray hose tub, being certain that
fiber washer remains in place in supply tube.
6. Connect the supply hoses to the hot and cold water
supply valves. When tightening the nut be sure
not to twist the hoses.
7. Attach counter weight to hose on spout side of loop,
just above bend ( use screws provided ).
8. Confirm that faucet operating handle is in closed
position and open supply valves, check connections
for leakage.
9. Disconnect spray head from hose and flush water
out until clear, to avoid problems with sprayhead
operation. Make sure that rubber washer remains
in place.
1. The aerator should be removed periodically and
cleaned, depending on the quality of water.
2. In order to maintain the sparkling appearance of
the finishes, wipe after each use with a soft cloth.
Use only a mild soap or household vinegar to clean
the faucet. Do not use steel wool or cleaning agenst
containing alcohol, acids, abrasives, etc.
Cleaning:
Operation:
1. The mixer is operated by moving the handle.
2. Swivel handle back and forward for cold and
hot water. For mixed water, keep tha handle in
the middle until the desired temperature is
reached.
3. To control the water flow, pull the handle away
from the body until you reach the desired flow.
4. On kitchen faucets:
a. The handspray can be drawn approximetly
500 mm (20”) out of the spout.
b. The flow of the water is changed from
aerator to spray mode by pushing down
upon the diverter button located on top of
the handspray.
c. After the water flow has been shut off,
the handspray automatically reverts back
to aerator mode.
Houzer Inc.
2605 Kuser Road, Hamilton, NJ 08691 p 800- 800-3639, f 877-880-3654 [email protected]
17 1/16 “ (433)
8 3/8 “ (212)
9 9/16 “ (243)
Max. temprature: 176 F (80 c)
Recommended pressure range: 15-88 PSI (1-6 bar)
  • Page 1 1

HOUZER VISPD-869-PC Installation guide

HOUZER
Brand
HOUZER
Model
VISPD-869-PC
Category
Faucets
Type
Installation guide
This manual is also suitable for

HOUZER VISPD-869-PC is a vision pull down faucet with a recommended pressure range of 15-88 PSI (1-6 bar) and a maximum temperature of 176 F (80 c). It features a mixer that is operated by moving the handle, allowing for precise control of water temperature and flow. The pull-out spray hose provides extended reach and versatility, with a flow that can be changed from aerator to spray mode by pushing down on the diverter button located on top of the handspray. After the water flow has been shut off, the handspray automatically reverts back to aerator mode.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents