Assembling:
l Put part 6 as right picture shown.
And screw 6 into extension handle (4)
l Put part 2 as right picture shown.
Then screw it into extension handle (3)
l Put part 7 as right picture shown.
Then screw it into part 5. (Hammer)
l Screw each parts as below:
Hammer, extension handle (short) + extension bar (longer) + shovel blade.
Adjusting Shovel blade:
Loose handle and adjust handle to expected angle.
Align the groove on handle collar with raise on steel
blade, then tight handle.
There are four raises on steel blade.
Adjusting to each angle, this product can be:
Shovel, hoe, shield.
Trademark Global LLC.