Vantec CB-ISA225-U3 User guide

Brand: Vantec

Model: CB-ISA225-U3

Type: User guide

Installation Guide

Model: CB-ISA225-U3www.vantecusa.com v1.01

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.

Printed in China

Printed on Recycled Paper.

When connected properly, the hard drive should be

automatically detected and begin ‘AutoPlay.’

AutoPlay

Disk(D:)

Open folder to view les

Prepare your device and the Adapter.

Verify the package contents.

Note that there is an On/Off switch located along the AC power

cable. Please make sure it is Off. (For 2.5” IDE, skip to Step 4c)

Carefully connect the desired hard drive to the adapter.

4a.

2.5”/3.5”/5.25” SATA Device

WARNING: Please make sure the power connectors are oriented

correctly before connecting. Incorrect connection may cause

severe damage to your hard drive and/or electrical shock.

To System USB port

Carefully connect the desired hard drive to the adapter.

4b.

3.5”/5.25” PATA(IDE) Device

*For Jumper settings, please refer to your hard drive manufacturer’s

documentation.

Note:

For ALL IDE device, please set the jumper setting on the drive to Master Single drive mode*.

To System USB port

Proceed to connect the Adapter’s USB to a free USB port.

AutoPlay

Disk(D:)

Open folder to view les

Carefully connect the desired hard drive to the adapter.

Proceed to step 6.

4c.

2.5” PATA(IDE) Device

To System USB port

Note:

Missing pin on the drive

Interface MUST align with the

plugged hole on the adapter

Interface side.

Once securely connected, you may switch ON the Adapter for device that need to

power using AC Adapter. For 2.5” PATA(IDE) device you can skip this step. After

Powering ON, wait 20 seconds before proceeding to the next step.

To System USB port

Vantec CB-ISA225-U3 User guide

Vantec CB-ISA225-U3 User guide

Vantec CB-ISA225-U3 User guide

Related papers

Other documents