Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall
Determine your desired location for installation and make a mark for the location of the mounting plate and CARD-58 CAP.
Remove mounting plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting
plate over mark made above. Then also make a mark for 2x CARD-58 CAP under glass 3 inches in from both ends of glass.
Make 4 marks where mounting screws will be placed as shown below. Drill hole at each of the mark. (You may substitute other
style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over holes and
secure to mounting surface using screws as shown below.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
PQN-1-24
MOUNTING PLATE
DRILLED HOLES
PERSPECTIVE
SCREW
DETAIL A
A
DETAIL B
B
SET SCREW
BACKPLATE
CARD-58
ANCHOR
DRILLED HOLE
MOUNTING PLATE
ANCHOR
DRILLED HOLE
Step1: Attach Bracket to Mounting Plate
Place bracket on mounting plate and secure by tightening set screw as shown below. To secure 2x CARD-58, screw the
bushing on to the wall and threading on the cap for the back of the shelf to rest on.
No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.
INSTALLATION INSTRUCTIONS
PQN-1-24
PERSPECTIVE
DETAIL D
DETAIL C
D
C
CARD-58(CAP)
SCREW
THREADED BUSHING
WALL ANCHOR
MOUNTING PLATE
SET SCREW
-
1
-
2
Allied Brass PQN-1-24-UNL Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Allied Brass PQN-1-24-GAL-SBR Installation guide
-
Allied Brass PQN-1-30-GAL-PB Installation guide
-
Allied Brass DT-1-24-GAL-ABZ Installation guide
-
-
Allied Brass 433D/24-PB Installation guide
-
-
-