L.A. Steelcraft LA-SW-342-503, LA-SW-342-505 Installation guide

Hello! I've reviewed the product details for the 342-505 HD Tire Swivel. This document outlines its features, including a heavy-duty construction, a rubber boot for joint protection, and grease fittings for easy maintenance. It also covers mounting options and maintenance guidelines. I'm ready to assist with any questions you may have.
What kind of rails can this swivel be mounted on?

How often should I check for loose bolts?

What should I do if I find a worn part?

342-505 HD Tire Swivel

Rev 03.24/03

*Heavy-Duty With Rubber Boot Which Shields the Universal Joint

*Complete with Grease Fittings for Easy Maintenance

*Three-Point Mounting System Reduces Tangles and Pinching

Includes the following hardware:

4-116-618 3/8” x 4 ½” Hex Bolts

8-316-601 3/8” Flat Washers

4-226-601 3/8” Lock Nuts

2-196-613 3/8” U-Bolts for 3 ½” O.D. Top Rail

Hardware is supplied for mounting on wood top rails (use flat plate) or 3 ½” O.D. pipe top rails (use U-

bolts)

Multi Axis Swings:

The Use/Fall Zone should extend in all directions the length of the swing plus six feet. The six-foot

minimum fall zone from the supporting structure also applies, and may overlap the six-foot zone of an

adjacent swing structure.

General Maintenance Instructions:

Check MONTHLY for loose bolts, damaged or broken parts. Tighten and/or replace immediately. On

swings and any equipment that uses S-hooks and/or swing hangers check the bearing surfaces for wear.

Replace any parts that show a reduction of 25% from the original size. Check swivel assembly to make

sure it is full of grease, if not fill with grease to prevent excessive wear on bearing.

1 CTN. 1 total piece Wt. 10 lbs., Class 70